SMUGDESK
SMUGDESK SFF8643 to 4× SFF8482 29Pin SAS 3.0 12Gbps Breakout Cable
Converts one SFF8643 host port into four 29pin SFF8482 drive connections for 12Gbps SAS 3.0 storage expansion
- SAS 3.0 12Gbps bandwidth handles enterprise storage workloads
- SFF8643 host splits to four independent 29pin SFF8482 drive interfaces
- Locking latches on both connectors prevent disconnection under rack vibration
- Shielded wiring reduces crosstalk for stable multi‑drive simultaneous operation
- Fanout layout simplifies internal routing and improves chassis airflow
Host-to-Drive Breakout Cable
This SMUGDESK breakout cable converts a single internal SFF8643 host port on a RAID or HBA controller into four independent SFF8482 29pin drive interfaces. It enables direct connection of up to four SAS or SATA hard drives inside rackmount servers and workstations. The design targets administrators expanding storage capacity through JBOD or RAID array deployments.
Signal Integrity and Secure Mating
Shielded internal wiring suppresses electromagnetic interference and crosstalk to maintain stable 12Gbps SAS 3.0 signalling during simultaneous multi-drive operation. Both the SFF8643 and SFF8482 connectors feature locking latches that resist disconnection caused by chassis vibration or cable movement. The fanout layout reduces internal clutter to support unrestricted chassis airflow.
Backward Compatibility and Forward Direction
The cable operates at 12Gbps per channel and remains compatible with 6Gbps and 3Gbps SAS and SATA drives for mixed-mode environments. It is built specifically for host-to-drive direction; the SFF8643 end attaches to the controller while the four SFF8482 ends attach to drives. No additional software or drivers are required for the physical link.
Highlights
- SAS 3.0 12Gbps bandwidth handles enterprise storage workloads
- SFF8643 host splits to four independent 29pin SFF8482 drive interfaces
- Locking latches on both connectors prevent disconnection under rack vibration
- Shielded wiring reduces crosstalk for stable multi‑drive simultaneous operation
- Fanout layout simplifies internal routing and improves chassis airflow
Specifications
No published specifications for this item yet.
Questions about this item
How do I install the SFF8643 breakout cable and what step is often missed?
Connect the SFF8643 end to the RAID or HBA controller first, then attach each of the four 29pin SFF8482 connectors to the SAS drives until the locking latches click; the step people miss is not fully seating both latches on every connector, which can cause drive dropouts under rack vibration.
What maintenance or replacement will this cable need later?
The shielded wiring and locking latches are designed for continuous server operation; no scheduled maintenance is required, but inspect latch integrity if drives are swapped frequently and replace the cable if any latch fails to snap securely.
What limit appears first during sustained multi-drive workloads?
Each of the four channels is capped at 12Gbps per the SAS 3.0 specification, so aggregate throughput is limited by the single SFF8643 host link and the 12Gbps per-channel ceiling when all four drives operate simultaneously.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114708BTC
In stock
