We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A .5 metre Mini SAS SFF-8643 cable splitting into four angled SATA connectors

SMUGDESK

SMUGDESK SFF-8643 to 4 SATA Target Angle Cable 0.5m

SKU CH-7EMY-ZRWMV

A .5 m shielded cable splits one SFF-8643 Mini SAS port into four angled SATA connectors for tidy internal drive wiring

  • Connect four drives from one controller port with SFF-8643 to 4 SATA design
  • Fit tight server bays using angled SATA connectors that reduce cable strain
  • Wire internal chassis cleanly with a 0.5m length suited for short runs
  • Maintain stable data transfers through shielded construction that cuts signal noise
  • Expand RAID or HBA storage systems with a cable built for server and storage use

Host-Side SFF-8643 Interface

This cable provides a single SFF-8643 Mini SAS connection that plugs into RAID controllers or HBA cards. It splits into four SATA outputs so one port can serve multiple hard drives or SSDs. The design targets builders assembling storage servers or expanding workstation drive counts.

Target-Angle SATA Connectors

Each of the four SATA plugs uses an angled profile that reduces cable bending inside tight chassis. The layout helps keep internal wiring tidy and avoids strain on drive ports. Shielded construction lowers signal interference for stable data transfer during continuous server operation.

0.5 Metre Internal Reach

The half-metre length suits typical distances between a controller card and drive bays in rackmount or tower enclosures. It handles SATA hard drives and SSDs in multi-disk arrays without excess slack. Buyers needing longer runs or additional controller ports will require a different cable.

Highlights

  • Connect four drives from one controller port with SFF-8643 to 4 SATA design
  • Fit tight server bays using angled SATA connectors that reduce cable strain
  • Wire internal chassis cleanly with a 0.5m length suited for short runs
  • Maintain stable data transfers through shielded construction that cuts signal noise
  • Expand RAID or HBA storage systems with a cable built for server and storage use

Specifications

No published specifications for this item yet.

Questions about this item

Does the 0.5m length reach from an SFF-8643 port to four drives in a 2U chassis?

The cable measures 0.5m (1.6FT), sized for internal server or storage chassis wiring between the host connector and four SATA drives.

How do the target angle SATA plugs orient during installation?

Each angled SATA connector is keyed; press it straight into the drive port until the latch clicks, avoiding side force that can bend the narrow plug.

When should the shielded cable be replaced in a RAID array?

Replace it if shielding damage appears, connectors loosen, or the controller logs recurring CRC errors on any of the four SATA links.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.