SMUGDESK
SMUGDESK SATA 15Pin 1 to 5 Power Splitter Cord 60CM
Splits one SATA power port into five to run multiple drives from a single PSU connector using 60 cm of thick copper cable
- Expands one SATA power port into five female connectors
- 60 cm length allows flexible routing inside desktop chassis
- Thick copper conductors minimise voltage drop under heavy load
- Molded strain relief protects wiring from bending damage
- Plug-and-play design simplifies DIY storage upgrades
SMUGDESK SATA 15Pin 1 to 5 Power Splitter Cord 60CM
This SATA 15Pin power splitter cable converts a single male SATA power connector from your ATX power supply into five female SATA power ports. The 60cm length provides flexible routing space inside desktop chassis for clean cable management. Thick copper conductors minimise voltage drop across all five outputs during peak drive activity. Molded strain relief at each joint protects internal wiring from bending stress during installation.
Suited for builders expanding internal storage
Ideal for DIY PC builds, storage array configurations and hard disk upgrade projects requiring multiple SATA drives from one PSU connector. Supports simultaneous power delivery to SATA HDDs, SSDs and optical drives. Not suitable for systems where total connected drive draw exceeds the PSU rail current limit. Buyers needing data transmission must use separate SATA data cables as this cord carries power only.
Five SATA power outputs from one connector
The splitter delivers five independent female SATA 15Pin power connectors from a single male source. Thickened copper wiring ensures stable voltage across all ports when multiple drives operate under load. Users must calculate combined device power consumption against PSU rail specifications before connecting the full complement of drives.
Highlights
- Expands one SATA power port into five female connectors
- 60 cm length allows flexible routing inside desktop chassis
- Thick copper conductors minimise voltage drop under heavy load
- Molded strain relief protects wiring from bending damage
- Plug-and-play design simplifies DIY storage upgrades
Specifications
No published specifications for this item yet.
Questions about this item
How do I install the 60cm SATA 15Pin 1-to-5 power splitter inside my desktop case?
Connect the single male SATA 15Pin plug to an available SATA power lead from your ATX power supply, then attach each of the five female connectors to the power ports on your SATA HDDs, SSDs or optical drives; the 60cm length gives enough slack to route cables neatly without sharp bends that could damage the molded strain reliefs.
What maintenance or replacement should I expect for the SATA 15Pin splitter over time?
The thick copper conductors and reinforced strain reliefs are built for continuous operation, so no routine maintenance is needed; inspect connectors for dust or loose fit during any major hardware change and replace the cord only if insulation shows cracking or a connector becomes intermittent.
What limit appears first when all five SATA drives run under sustained load?
The total current drawn by the five drives must stay within the rating of the single PSU rail feeding the male SATA 15Pin connector; exceeding that rail limit will cause voltage drop or shutdown before the splitter’s own copper wiring reaches its capacity.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115201BTC
In stock
