We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short black adapter cable with XLR male and RJ45 female connectors, 30cm long

SMUGDESK

SMUGDESK RJ45 to 3Pin XLR Adapter Cable 30cm

SKU CH-MBGV-NX6FY

Converts 3-pin XLR male to RJ45 female for audio and DMX signal transfer in 30cm length

  • Converts XLR to RJ45 for audio-network integration
  • Stable audio and DMX signal transmission for stage use
  • Compact 30cm length enables tidy rack wiring
  • Works with amplifiers, mixers, KTV and lighting gear
  • Plug-and-play durability suits live-event installations

Compact Adapter for Audio and Lighting Systems

This 30 cm cable converts a 3-pin XLR male connector to an RJ45 female port, linking professional audio gear with network-style connections. It suits venues and live events where amplifiers, mixers, KTV equipment or stage lighting must be integrated quickly. No drivers are required, so the link works immediately on standard sound and DMX control setups. The short length keeps rack and truss wiring tidy.

Passive Design Means No Extra Power or Noise

The adapter draws no power and adds no active electronics, so it introduces no fan noise, coil whine or heat into the signal chain. Signal integrity relies on the quality of the connected devices and the cables plugged into each end. Because it is entirely passive, there is no power draw to budget for in a rack or portable rig. Installation is a simple plug-in step during normal system setup.

Rugged Connectors Built for Frequent Patching

Metal XLR and RJ45 shells withstand repeated insertion in touring and fixed-install environments. The 30 cm tail reduces strain on panel-mounted ports when gear is moved or reconfigured between shows. Pin mapping follows the standard audio-to-Ethernet convention used in DMX and analogue audio distribution. Users needing longer runs or different pinouts will require a separate cable assembly.

Highlights

  • Converts XLR to RJ45 for audio-network integration
  • Stable audio and DMX signal transmission for stage use
  • Compact 30cm length enables tidy rack wiring
  • Works with amplifiers, mixers, KTV and lighting gear
  • Plug-and-play durability suits live-event installations

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the XLR male end to my mixer without damaging the pins?

Align the three pins on the XLR male connector with the corresponding sockets on your mixer or amplifier, then push straight in until the latch clicks. Forcing it at an angle bends the pins.

Will the RJ45 female jack wear out after repeated plugging and unplugging?

The RJ45 jack is rated for standard mating cycles; if the latch tab breaks or contacts oxidise, replace the whole 30cm adapter cable.

What signal drop should I expect on a 30cm run carrying DMX lighting data?

At 30cm the adapter adds negligible loss; the first limit under sustained use is the quality of the Ethernet patch cord you plug into the RJ45 side.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.