We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black SFF-8087 Mini SAS cable splitting into four SATA connectors, 1 meter length

SMUGDESK

SMUGDESK Mini SAS SFF-8087 to 4 SATA Breakout Cable 1M

SKU CH-0WBP-F0N3A

Converts a single Mini SAS SFF-8087 port into four SATA connections for 2.5 or 3.5 drives, with a 3.3 ft length for flexible server routing

  • Converts one Mini SAS port to four SATA drives
  • 1 meter length enables flexible routing in server chassis
  • High-speed signal transmission suits RAID controllers and storage servers
  • Reinforced molded connectors resist vibration for stable operation
  • Supports 2.5 and 3.5 SATA HDD and SSD drives

Server storage expansion

This 1M Mini SAS forward breakout cable converts a single SFF-8087 port into four independent SATA interfaces. It connects RAID controllers and storage servers directly to 2.5 and 3.5 SATA drives. The design suits DIY NAS builds, server upgrades and data centre storage arrays.

Thermals noise and power

Passive copper conductors carry data without active cooling or external power draw. Molded connector shells absorb vibration from chassis fans and drive movement. The 1M length allows routing away from high-airflow zones to reduce cable stress.

Bundled value

No additional accessories or software are included with the cable. The reinforced connectors themselves provide the strain relief that prevents loose contacts during long-term operation. Buyers needing latch-equipped SATA cables or angled connectors must source them separately.

Highlights

  • Converts one Mini SAS port to four SATA drives
  • 1 meter length enables flexible routing in server chassis
  • High-speed signal transmission suits RAID controllers and storage servers
  • Reinforced molded connectors resist vibration for stable operation
  • Supports 2.5 and 3.5 SATA HDD and SSD drives

Specifications

No published specifications for this item yet.

Questions about this item

How do I plug the SFF-8087 end into my RAID controller without bending the pins?

Align the keyed SFF-8087 male connector with the controller port, press straight in until the latch clicks, and route the 1M cable so the four SATA tails have no sharp bends near the backplane.

Which part of this breakout cable wears out first and needs replacing?

The SATA data connectors see the most insertions; if a drive swap feels loose or shows intermittent errors, replace the whole 1M assembly rather than re-using a stretched latch.

What speed limit appears first when the array runs flat-out for hours?

The SATA 3.5 Gb/s or 6 Gb/s link on each drive caps sustained throughput long before the Mini SAS trunk saturates.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.