We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black mini 4-pin splitter cable with two right-angle 15-pin SATA connectors, 90-degree L-shaped plugs

SMUGDESK

SMUGDESK Mini 4-Pin to 2X Right Angle SATA Power Cable

SKU CH-RFN1-ZJGNG

Converts a single mini 4-pin power port into two right-angle SATA 15-pin connectors for powering dual drives in compact cases

  • Converts one mini 4-pin port into two SATA power outputs
  • Right-angle 90-degree SATA plugs save space inside compact chassis
  • High-conductivity wiring delivers stable power to SSDs and HDDs
  • Compact splitter layout simplifies cable routing in mini ITX builds
  • Compatible with SATA SSDs, mechanical drives and optical devices

Mini 4-Pin Splitter for Dual SATA Drives

This cable converts a single mini 4-pin power port into two right-angle SATA 15-pin connectors. It lets you power two SATA SSDs or hard drives from one header on a mini ITX motherboard or compact chassis. Builders working with limited internal space gain an extra drive connection without adding a second power cable.

Right-Angle Design Reduces Cable Strain

The 90-degree SATA plugs sit flush against the drive, preventing the cable from bending sharply in tight cases. This layout protects the connector and the drive socket from mechanical stress during assembly or transport. High-conductivity wiring delivers stable power to both drives under normal operating loads.

Compact Wiring Suited to Small Builds

Precision-moulded connectors and a short splitter keep the harness tidy inside mini PCs and small-form-factor desktops. The right-angle orientation helps route cables along the chassis wall rather than across components. Users must verify that the source header can supply enough current for both attached drives to avoid unstable operation.

Highlights

  • Converts one mini 4-pin port into two SATA power outputs
  • Right-angle 90-degree SATA plugs save space inside compact chassis
  • High-conductivity wiring delivers stable power to SSDs and HDDs
  • Compact splitter layout simplifies cable routing in mini ITX builds
  • Compatible with SATA SSDs, mechanical drives and optical devices

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the mini 4-pin splitter to my mini ITX board and the two SATA drives?

Plug the single mini 4-pin connector into the motherboard power header, then attach each 90-degree right-angle 15-pin SATA plug to a SSD or hard drive; the L-shaped ends keep cables flat in tight chassis space.

Will the right-angle SATA connectors or the mini 4-pin plug wear out and need replacing?

The moulded connectors and high-conductivity wiring are built for long-term use; no periodic replacement is expected unless physical damage occurs from repeated unplugging.

What power limit should I watch when running both drives continuously?

The single mini 4-pin source must supply enough current for two SATA devices; exceeding that limit can cause unstable operation, so verify your power supply rating before sustained use.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.