We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black cable with one 4-pin IDE plug branching into six SATA power connectors

SMUGDESK

SMUGDESK LP4 4 Pin IDE to 6 SATA Power Splitter Cord

SKU CH-06G9-C27VV

Turns one LP4 4-pin IDE connector into six 15-pin SATA power ports for multi-drive PC and server builds

  • Converts one LP4 port into six SATA power outputs for multi-drive setups
  • Supplies steady power to HDDs SSDs and optical drives with high-quality wiring
  • Secure locking SATA connectors prevent accidental disconnection from chassis vibration
  • Expands SATA power capacity without replacing the existing power supply
  • Practical accessory for DIY builds multi-drive storage and small server projects

Power expansion for multi-drive builds

This LP4 4 Pin IDE to SATA power splitter cable converts a single 4-pin Molex connector into six 15-pin SATA power ports. It suits PC builders and server technicians who need to add multiple hard drives, solid state drives or optical drives without replacing the power supply. The adapter supports desktop and server equipment requiring additional SATA power connections. It is not for systems that lack a spare 4-pin LP4 output or for builders who need a different connector type.

Steady output during extended operation

Reinforced wiring and connector joints maintain consistent power transmission when several drives run simultaneously for long periods. Standard locking SATA terminals resist disconnection caused by chassis vibration inside a server or workstation. The design prioritises stable operation for multi-drive arrays over short-burst performance. Users must verify that the host power supply delivers sufficient total wattage for all attached devices.

Six SATA ports from one LP4 input

The single specification that decides fit is the 15-pin SATA output count: six ports branch from one LP4 source. This fixed ratio determines how many SATA-powered drives the cable can support in a given build. No other interface or connector variant is provided by this adapter.

Highlights

  • Converts one LP4 port into six SATA power outputs for multi-drive setups
  • Supplies steady power to HDDs SSDs and optical drives with high-quality wiring
  • Secure locking SATA connectors prevent accidental disconnection from chassis vibration
  • Expands SATA power capacity without replacing the existing power supply
  • Practical accessory for DIY builds multi-drive storage and small server projects

Specifications

No published specifications for this item yet.

Questions about this item

Does the LP4 4 Pin IDE to 6 SATA power splitter generate noticeable heat or noise when powering several drives continuously?

The cable uses high-quality wire cores and reinforced joints to maintain steady power transmission during long-hour operation, so it runs silently and without excess heat under normal loads.

What must my power supply already have for this adapter to work?

Your power supply needs at least one free standard 4-pin LP4 Molex connector to serve as the single input for the splitter.

Will the splitter work reliably with older IDE-era hard drives and optical drives I still use?

The adapter converts one LP4 Molex input into six 15-pin SATA power outputs, so it only powers SATA drives and peripherals; older IDE drives that require a Molex power plug cannot be powered directly from this cable.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.