We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 30cm ATX 24-pin male to dual female power splitter cable with moulded connectors

SMUGDESK

SMUGDESK ATX 24Pin 1-to-2 Power Splitter Cord 30cm

SKU CH-H3GR-KSFGZ

A 30 cm ATX 24-pin splitter turns one PSU connector into two for dual motherboard or test rig setups

  • One PSU connector powers two motherboards via 1-to-2 splitter design
  • 20+4 pin modular structure fits both 20-pin and 24-pin ATX boards
  • 30 cm length enables tidy internal routing and better case airflow
  • High-purity copper conductors minimise voltage drop under heavy load
  • Flame-retardant moulded connectors ensure tight fit and prevent power failure

Power Splitter for Dual Motherboards

This SMUGDESK ATX cable splits one 24-pin PSU output into two 24-pin female connectors. It targets builders running dual-mainboard test platforms or specialised industrial equipment that requires simultaneous power from a single supply. The 30cm length keeps internal routing tidy inside standard chassis.

20+4 Pin Modular Compatibility

The connector uses a detachable 20+4 pin design that fits both legacy 20-pin and modern 24-pin ATX motherboards. High-purity copper conductors minimise voltage drop under load, while flame-retardant moulded shells ensure a tight, secure fit that resists accidental disconnection during operation.

Dual-Board Power Distribution

The splitter comfortably handles power delivery for two ATX motherboards drawing from one PSU, simplifying multi-system test benches. It runs out when the combined draw exceeds the single PSU's rated 24-pin output capacity, requiring a higher-wattage unit or separate supplies for heavy configurations.

Highlights

  • One PSU connector powers two motherboards via 1-to-2 splitter design
  • 20+4 pin modular structure fits both 20-pin and 24-pin ATX boards
  • 30 cm length enables tidy internal routing and better case airflow
  • High-purity copper conductors minimise voltage drop under heavy load
  • Flame-retardant moulded connectors ensure tight fit and prevent power failure

Specifications

No published specifications for this item yet.

Questions about this item

How much extra reach does the 30 cm length give when routing power to a second motherboard inside the same chassis?

The 30 cm cable lets you bridge from the PSU's single 24-pin output to two separate 24-pin motherboard sockets without stretching or sharp bends, keeping airflow paths clear.

What does the 20+4 pin modular design mean for compatibility with older 20-pin boards and modern 24-pin ATX boards?

The connector splits into a 20-pin section and a 4-pin section, so it plugs directly into legacy 20-pin motherboards or combines for current 24-pin ATX motherboards without adapters.

How much clearance is needed behind the motherboard tray to accommodate the dual female connectors on this splitter?

Each female port adds the depth of a standard ATX 24-pin socket; allow enough rear-panel space for both plugs to seat fully without pressing against the case side panel.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.