We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four black right-angle DC 5.5x2.1mm male pigtail cables with stripped bare-wire ends

SMUGDESK

SMUGDESK 4 Pack Right Angle DC 5521 Male Power Pigtail Cables 5.5x2.1mm 90 Degree 18AWG .5M 1.6FT

SKU CH-D6B9-FS1XQ

Four right-angle 5.5×2.1 mm DC 5521 male pigtails with 18 AWG copper wire and 0.5 m bare-wire leads for power-cord repair

  • 90-degree right-angle plug saves space and prevents wire bending damage
  • 18AWG copper conductors ensure stable current transmission with minimal voltage drop
  • .5m (1.6ft) fixed length with pre-stripped bare ends for direct soldering or terminal connection
  • Pack of four cables provides cost-effective spares for multiple device repairs
  • Suitable for DC power cord replacement, CCTV cameras, LED strips and small equipment wiring

Right-Angle DC 5521 Power Pigtails

This pack supplies four 0.5 metre cables fitted with a 90-degree 5.5x2.1mm male plug and stripped bare ends. The L-shaped connector saves space inside tight equipment casings and prevents sharp wire bends that damage conductors. Each lead uses 18AWG copper for stable current flow with minimal voltage drop. They suit CCTV cameras, LED strips, routers and similar low-voltage DC devices needing a replacement or custom power lead.

Replaces Damaged Straight-Plug Leads

Swap out cracked or kinked straight connectors that stress the jack and fail prematurely. The right-angle geometry is worth the change when the socket sits flush against a wall, panel or crowded chassis where a straight plug would protrude or snag. Buyers who need a longer reach between the power source and the device cannot extend these fixed 1.6 foot lengths without adding a junction.

Solder-Ready Bare Ends Install Fast

The tail arrives pre-stripped with two exposed wires, ready for soldering, crimp terminals or direct module insertion without extra prep. Polarity is not marked on the cable, so verify positive and negative with a multimeter before connecting to avoid reverse-voltage damage. The flexible PVC sheath resists daily bending, but the short length limits routing options in larger enclosures.

Highlights

  • 90-degree right-angle plug saves space and prevents wire bending damage
  • 18AWG copper conductors ensure stable current transmission with minimal voltage drop
  • .5m (1.6ft) fixed length with pre-stripped bare ends for direct soldering or terminal connection
  • Pack of four cables provides cost-effective spares for multiple device repairs
  • Suitable for DC power cord replacement, CCTV cameras, LED strips and small equipment wiring

Specifications

No published specifications for this item yet.

Questions about this item

What plug size does the 90-degree right-angle connector use?

The L-shaped male plug measures 5.5 mm outer diameter and 2.1 mm inner pin, matching the standard 5521 barrel specification.

How should the 0.5 m pigtail be terminated for a secure connection?

Each cable ends with two pre-stripped bare wires; solder them directly or crimp suitable terminals for a reliable joint.

When should the 18AWG copper conductors be inspected or replaced?

Check the PVC sheath for cracking or heat discolouration after prolonged use; replace any cable showing insulation damage to maintain safe power delivery.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.