We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board adapter with SATA and power connectors, converts 39 pin IDE 3.5 inch drive

SMUGDESK

SMUGDESK 39Pin IDE to SATA Adapter for 3.5" HDD with Data & Power Cable

SKU CH-5FWP-A40QF

Converts 39pin IDE 3.5inch hard drives to SATA with included data and power cables for data recovery

  • Converts 39-pin IDE drives to standard SATA interface
  • Includes matching data cable and power cable for full connection
  • Enables data reading, backup and recovery from legacy IDE disks
  • Compact PCB board works plug-and-play without firmware setup
  • Suited for repair shops and vintage hardware data rescue

39-Pin IDE to SATA Converter

This adapter board converts a 39pin IDE PATA 3.5inch hard drive to a standard SATA interface. It includes a matched SATA data cable and power cable for a complete connection set. The compact PCB design enables plugandplay operation without firmware setup. It suits computer repair shops and anyone performing vintage hardware data rescue work.

Users with 3.5inch IDE drives needing SATA host

This suits technicians recovering files from retired 3.5inch IDE hard disks and builders integrating legacy storage into modern systems. It is not for users with 2.5inch laptop IDE drives or SCSI interfaces. It will not work with drives that require proprietary connectors beyond the standard 39pin layout. Buyers who need to connect multiple drives simultaneously should look at a multi-port solution.

39pin IDE PATA to SATA signal conversion

The single specification that decides fit is the 39pin IDE PATA interface on the source hard drive. The adapter bridges this specific legacy protocol to a SATA host port for readwrite access. Performance remains limited by the original IDE hard disk speed. Confirm the drive uses a 39pin connector before purchase.

Highlights

  • Converts 39-pin IDE drives to standard SATA interface
  • Includes matching data cable and power cable for full connection
  • Enables data reading, backup and recovery from legacy IDE disks
  • Compact PCB board works plug-and-play without firmware setup
  • Suited for repair shops and vintage hardware data rescue

Specifications

No published specifications for this item yet.

Questions about this item

Will the 39pin connector or the SATA data cable need replacing after heavy use?

The adapter board and cables are solid‑state with no moving parts; only the attached 3.5inch IDE drive itself may eventually require replacement.

What limits transfer speed when the adapter runs continuously?

The original IDE hard disk’s own maximum throughput is the bottleneck; the converter simply passes those signals to the SATA host.

Does the board generate noticeable heat or draw extra power during all‑day operation?

The passive PCB adds negligible heat and draws only the tiny current needed for signal conversion; the 3.5inch drive dominates power use and temperature.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.