We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A compact circuit board with three toggle switches and an 80 mm low-profile metal bracket attached

SMUGDESK

SMUGDESK 3-Port SATA Power Switch Selector with 80mm Low-Profile Bracket

SKU CH-GTE7-X69F7

It provides manual power switching for up to three SATA drives, cutting idle power and noise while fitting standard cases with an 80 mm low-profile bracket

  • Manual power control for up to three SATA drives
  • Cuts idle power to lower heat, noise and extend drive life
  • 80 mm low-profile bracket fits standard PC cases
  • Works with 2.5" and 3.5" SATA storage devices
  • One-key hardware switching, no software or drivers needed

Independent Power Control for Three SATA Drives

This SMUGDESK module lets you manually switch power to up to three SATA HDDs or SSDs independently. It is designed for users who run multi-drive PCs, home NAS units or backup systems and want to keep idle drives completely offline. No software or drivers are required, so it works with any system that provides standard SATA power connections.

Cuts Idle Power, Heat and Noise

By turning off drives that are not in use, the selector reduces overall power draw and lowers the heat produced inside the chassis. Less heat means case fans can run slower, which reduces acoustic noise during normal operation. The approach also helps extend the service life of mechanical hard drives by avoiding unnecessary spin time.

80 mm Low-Profile Bracket for Standard Cases

The module ships with an 80 mm low-profile mounting bracket that fits typical PC chassis cut-outs. Its compact form factor supports both 2.5" and 3.5" SATA storage devices without blocking adjacent slots. Simple one-key hardware toggles give immediate control, making day-to-day drive management straightforward for multi-disk setups.

Highlights

  • Manual power control for up to three SATA drives
  • Cuts idle power to lower heat, noise and extend drive life
  • 80 mm low-profile bracket fits standard PC cases
  • Works with 2.5" and 3.5" SATA storage devices
  • One-key hardware switching, no software or drivers needed

Specifications

No published specifications for this item yet.

Questions about this item

How is the 80 mm low-profile bracket mounted inside a standard PC case?

The bracket aligns with an 80 mm fan opening or rear slot and is secured with standard case screws; the module then plugs into a single SATA power connector from the PSU and distributes power to up to three drives via individual on/off switches.

What ongoing maintenance or replacement does the selector module require?

No scheduled maintenance is needed; the unit has no moving parts or firmware. If a switch feels loose or a drive stops receiving power, replace the module itself.

What is the first limit reached when all three drives run continuously?

The single SATA power input from the PSU sets the total current ceiling, so combined drive draw must stay within that connector's rating.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.