We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
30-inch SATA cable straight to right-angle connector, black flat ribbon with dual 7-pin female ends

SATAGear

SATAGear SS-075MSR SATA cable 30in straight to right angle

SKU CH-H89C-BXDER

A 30-inch internal SATA cable with straight and right-angle 7-pin connectors supports 6.0 Gbps transfer rates

  • 0 Gbps data rate for fast drive performance
  • 30 inch right-angle connector eases tight-case routing
  • Shielded 7-pin SATA cable resists EMI interference
  • Narrow design improves internal airflow and cable management
  • Meets SATA 1.0 specification for broad device compatibility

Cable orientation and length

The SATAGear SS-075MSR is a 30in internal SATA cable with a straight connector on one end and a right-angle connector on the other. It connects a Serial ATA hard drive, optical drive or other SATA device to a motherboard or controller card. The 75cm length suits standard desktop or server chassis where drives sit close to the board.

Narrow shielded design

The slim profile simplifies routing and leaves more room for airflow compared with older ribbon cables. Shielding protects the signal from EMI and RFI, while dual 7-pin female connectors ensure a secure fit on both the device and the controller.

SATA 1.0 interface limit

The cable meets the Serial ATA 1.0 standard and supports data rates up to 6.0 Gbps. It cannot exceed the bandwidth ceiling defined by that specification, so newer controllers will operate at the link speed the standard allows. Builders needing longer reach or a different connector angle will require another cable.

Highlights

  • 0 Gbps data rate for fast drive performance
  • 30 inch right-angle connector eases tight-case routing
  • Shielded 7-pin SATA cable resists EMI interference
  • Narrow design improves internal airflow and cable management
  • Meets SATA 1.0 specification for broad device compatibility

Specifications

ModelSS-075MSR

Questions about this item

Will the 7-pin female connectors on this SS-075MSR cable wear out after repeated drive swaps?

The connectors are rated for standard SATA mating cycles; avoid excessive force when inserting or removing to maintain reliable contact over time.

What is the maximum data rate this 30-inch straight-to-right-angle cable can sustain without errors?

The cable supports up to 6.0 Gbps per the SATA 1.0 specification; actual sustained throughput depends on the drive and controller capabilities.

Does the shielded narrow design keep the cable cool and quiet when drives run continuously in a server?

The shielded narrow profile improves internal airflow and reduces EMI/RFI; the cable itself generates no noise or heat during operation.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.