We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short 4-inch SATA cable with straight 7-pin female connectors at both ends

SATAGear

SATAGear SS-01MSS SATA cable 4 in straight to straight

SKU CH-V0SW-DSSRF

A 4-inch internal SATA III cable with straight 7-pin female connectors on both ends, supporting 6.0 Gbps data transfer and a narrow, shielded design for improved airflow

  • Cable Length4 in.
  • SATA III revision 3.0 supports up to 6.0 Gbps throughput
  • 4-inch length keeps cable routing tidy inside the case
  • Narrow cable design improves internal airflow around components
  • Dual 7-pin female connectors fit standard SATA devices directly
  • Shielded construction protects signals from EMI and RFI interference

4-Inch Internal SATA III Cable

This 4-inch internal cable connects Serial ATA drives and optical devices to a motherboard or controller. Both ends carry a straight 7-pin female connector for a direct device-to-board link. It is built for tight spaces inside desktops or servers where a short run keeps routing clean.

Builders with stacked drives or cramped bays

The short length suits installations where the drive sits close to the SATA port. Builds that need longer reach between separated components should choose a different cable. The straight connectors also require enough clearance behind the drive for a straight plug.

4-inch cable length

At four inches the cable only spans a very short distance between the drive and the motherboard port. Measure the exact routing path before ordering to confirm the length is sufficient for your chassis layout.

Highlights

  • SATA III revision 3.0 supports up to 6.0 Gbps throughput
  • 4-inch length keeps cable routing tidy inside the case
  • Narrow cable design improves internal airflow around components
  • Dual 7-pin female connectors fit standard SATA devices directly
  • Shielded construction protects signals from EMI and RFI interference

Specifications

ModelSS-01MSS
Cable Length4 in.

Questions about this item

What connectors come on the SATAGear SS-01MSS cable and do I need anything else?

The cable has dual 7-pin female SATA connectors on each end. No additional parts are required for a standard internal drive connection.

Which version of this cable should I choose for a 6 Gbps drive?

This model is a SATA revision 3.0 cable rated for up to 6.0 Gbps, so it matches the drive's maximum interface speed.

What does the 6.0 Gbps figure mean when the cable is installed in my system?

It is the peak interface bandwidth of the SATA 3.0 link; actual throughput depends on the drive and controller performance.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.