We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Down-angled SATA data and power combo cable with 18 inch data and 22 inch power lengths

SATACables

SATACables DA22-18-6 SATA cable 18 inch data 22 inch power

SKU CH-SSJH-TS52G

Down-angle SATA cable combining an 18-inch data lead with a 22-inch power lead for internal drive connections

  • Down-angle connector eases tight drive bays
  • 18 inch data cable reaches across full-tower cases
  • 22 inch power lead spans PSU to drive
  • Single combo cable carries both SATA signals and power

Down-Angle SATA Combo Cable

This down-angle moulded cable combines data and power connections for any SATA drive. The 18 inch flexible data lead and 22 inch power lead reduce strain on drive ports in tight chassis. The angled connector eases routing behind stacked drives or against side panels. It suits builders who need a single tidy link for SSDs or hard disks.

Capacity and Headroom

The cable carries standard SATA II signalling and power for one drive, so it handles typical SSD and mechanical workloads without bottleneck. It runs out when a build requires straight or upward-facing connectors, longer reach than the fixed lead lengths, or multiple drives from one cable. Buyers needing right-angle, left-angle or extended runs must choose a different variant.

Highlights

  • Down-angle connector eases tight drive bays
  • 18 inch data cable reaches across full-tower cases
  • 22 inch power lead spans PSU to drive
  • Single combo cable carries both SATA signals and power

Specifications

ModelDA22-18-6

Questions about this item

Will the 18 inch data cable reach my drive if the motherboard port is far from the drive bay?

The cable provides an 18 inch data run and a 22 inch power run, so measure your routing path to confirm the lengths suit your case layout.

How can I verify the down angle connector is seated correctly after installation?

The molded down angle connector should sit flush against the drive’s SATA port with no visible gap, and the system should detect the drive at SATA II speeds on first boot.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.