We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Grey ribbon cable with multi-pin connectors for M600 tripod control board

Ruth's sister

Ruth's sister Tripod Control Board Signal Cable M600

SKU CH-DAEJ-Q48FD

Tripod control board signal cable for warp and weft M600/M600 PRO

  • Tripod control board signal cable for warp and weft M600/M600 PRO
  • Internal power cable designed for M600 series compatibility
  • New condition ensures reliable signal transmission for tablet LCD components
  • Components & Storage cable category for internal system integration

Tripod Signal Cable M600

This cable links the tripod control board to the warp and weft modules on the M600 and M600 Pro systems. It is built for technicians who service or assemble these specific units. The connection carries the signals that coordinate the moving parts during operation.

Sustained signal integrity

Shielded conductors keep the link stable during long production runs or repeated calibration cycles. The design resists the electrical noise that can appear when motors and heaters cycle continuously. Builders needing cables for other controller revisions should verify pinouts before ordering.

Highlights

  • Tripod control board signal cable for warp and weft M600/M600 PRO
  • Internal power cable designed for M600 series compatibility
  • New condition ensures reliable signal transmission for tablet LCD components
  • Components & Storage cable category for internal system integration

Specifications

No published specifications for this item yet.

Questions about this item

How much power does the M600 signal cable draw when the tripod runs continuously?

The cable itself draws no power; it only carries low-voltage signals between the control board and the warp and weft mechanism.

What connectors must already be on my tripod for this M600 cable to plug in?

Your tripod needs the matching control-board header and the warp-and-weft signal socket that the M600/M600 PRO uses.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.