We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
RS232 DB9 male to IDC 10 female ribbon cable with full-height bracket

Ruth's sister

Ruth's sister RS232 DB9 Male to IDC 10 Female Ribbon Cable Full-height Bracket 0.28m

SKU CH-G8XB-T1W7B

Connects a DB9 serial port to a 10-pin IDC header using a 0.28 m ribbon cable with a full-height bracket

  • Connect legacy serial equipment with DB9 male to IDC 10 female interface
  • Secure full-height bracket mounting fits standard PC expansion slots
  • Compact 0.28 m ribbon cable keeps internal routing tidy
  • Direct RS232 signal path needs no active conversion circuitry

RS232 DB9 male to IDC 10 female bracket

This Ruth's sister cable converts a serial DB9 port to a 10-pin IDC header on a full-height bracket. The 0.28 m ribbon links legacy RS232 equipment to modern motherboard or expansion headers. It ships new and ready for internal installation.

Not for USB or parallel ports

Builders who need USB headers, parallel ports or longer cable runs cannot use this item. Systems without a free full-height bracket slot or a compatible 10-pin header should look elsewhere.

Highlights

  • Connect legacy serial equipment with DB9 male to IDC 10 female interface
  • Secure full-height bracket mounting fits standard PC expansion slots
  • Compact 0.28 m ribbon cable keeps internal routing tidy
  • Direct RS232 signal path needs no active conversion circuitry

Specifications

No published specifications for this item yet.

Questions about this item

Does the 232 serial bracket need a free 10-pin IDC header on my motherboard?

Yes, the ribbon end plugs into an internal 10-pin IDC header; without one the bracket cannot connect.

Will the 0.28 m ribbon reach a rear-panel cut-out if my board header sits near the front edge?

At 0.28 m the cable suits typical ATX layouts; measure header-to-slot distance before fitting.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Internal Power Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.