We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Dashboard phone holder with air vent clip and windshield mount for 4.7 to 6.8 inch phones

Ruth's sister

Ruth's sister Internal Power Cable 4.7-6.8inch

SKU CH-ABPJ-DS2Y2

Holds phones from 4.7 to 6.8 inches on dashboard, air vent or windshield

  • Fits phones from 4.7 to 6.8 inches
  • Air-vent mount keeps dashboard clear
  • Windshield option adds placement flexibility
  • GPS support aids navigation while driving

Dashboard phone holder for 4.7 to 6.8 inch devices

This air vent and windshield mount secures smartphones within the 4.7 to 6.8 inch range for navigation and hands-free use. It attaches to dashboard vents or glass surfaces without permanent installation. Drivers who need a single adjustable cradle for daily commuting will find it fits common handset sizes. The holder does not charge the phone or integrate with vehicle infotainment systems.

Thermals noise and power draw in normal use

The mount has no electronic components so it generates no heat and draws no power from the vehicle. Operation is completely silent because there are no fans or motors. Vibration from the engine or road surface is the only mechanical sensation transmitted to the phone. No cooling or electrical capacity planning is required.

Highlights

  • Fits phones from 4.7 to 6.8 inches
  • Air-vent mount keeps dashboard clear
  • Windshield option adds placement flexibility
  • GPS support aids navigation while driving

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the air-vent mount on the dashboard holder, and which step is often missed?

Clip the vent bracket onto a horizontal louvre, then tighten the locking nut until the arm cannot pivot; the step most people skip is fully tightening that nut, which lets the holder sag.

What maintenance or replacement will the 4.7-6.8inch phone holder need later?

The spring-loaded grip arms and vent-clip teeth can lose tension over time; if the phone slips or the clip no longer holds the louvre, replace the entire holder unit.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Internal Power Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.