We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue internal power cable for DC power analyzer

Ruth's sister

Ruth's sister Blue DC 60V 100A Power Analyzer internal power cable

SKU CH-ZR0S-JX0Q6

Measures voltage, current and power up to 60 V and 100 A for RC battery analysis

  • Measures up to 60 V for safe RC power checks
  • Handles 100 A current to support high-draw setups
  • Combines watt-meter, balancer and checker in one tool
  • New condition ensures reliable performance from first use

Blue DC 60V 100A Power Analyzer

This internal power cable connects a Blue DC power analyzer to a battery pack for real-time monitoring. It supports measurements up to 60 volts and 100 amps during charge or discharge cycles. The assembly is intended for hobbyists and technicians who need precise voltage and current data on RC power systems. Condition is new and ready for installation.

Capacity and headroom

The cable handles the analyzer’s full 60 V and 100 A rating so it will not limit logging during high-current runs. It runs out of headroom if the pack voltage exceeds 60 V or the current draw surpasses 100 A, at which point the analyzer cannot record accurate readings. Builders needing higher voltage or current specifications must select a different analyzer and matching cable.

Highlights

  • Measures up to 60 V for safe RC power checks
  • Handles 100 A current to support high-draw setups
  • Combines watt-meter, balancer and checker in one tool
  • New condition ensures reliable performance from first use

Specifications

No published specifications for this item yet.

Questions about this item

Will the 60V 100A power analyzer work with my existing RC battery packs and connectors?

The analyzer supports up to 60 volts and 100 amps, so it will handle any pack that stays within those limits; match the connector type on your current leads to the unit's terminals.

How do I confirm the 60V 100A watt meter is reading correctly after I wire it in?

Apply a known load such as a calibrated resistor or a motor with a documented current draw, then compare the displayed voltage, current and power values to the expected figures.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Internal Power Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.