We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat ribbon cable splitting one 6-pin connector into two 6+2-pin connectors, 50cm long

Ruth's sister

Ruth's sister 6Pin to Dual 6+2Pin Splitter Ribbon Cable 18AWG 50cm

SKU CH-77Q2-D316R

Converts a single 6-pin PSU connector into two 6+2-pin GPU power plugs using 18 AWG ribbon cable 50 cm long

  • Splits one 6-pin into two 6+2-pin connectors for dual GPU power
  • 18 AWG conductors handle high current with minimal voltage drop
  • 50 cm ribbon layout keeps cable routing tidy inside the case
  • Red plug marks PSU end, black plug marks GPU end for error-free connection
  • Compatible with Anatek NP, TP and Zun series modular power supplies

Power splitter for dual GPU connectors

This 18AWG ribbon cable splits a single 6-pin modular PSU output into two 6+2-pin PCIe connectors. It is intended for builders who need to power a graphics card that requires two 8-pin inputs from a power supply with limited native PCIe leads.

Verify modular PSU pin-out before connecting

The red 8-pin end plugs into the power supply and the black ends plug into the graphics card. Because modular pin-outs vary by manufacturer, confirm that the PSU side matches the Anatek NP, TP or Zun series layout described. Do not use with other power supplies unless the pin-out is identical.

18AWG conductors on a 50cm flat ribbon

The flat ribbon construction keeps the two output leads together for tidy routing inside the case. 18AWG wire handles the current required by typical dual 8-pin graphics cards. The fixed 50cm length suits standard ATX chassis layouts without excess slack.

Highlights

  • Splits one 6-pin into two 6+2-pin connectors for dual GPU power
  • 18 AWG conductors handle high current with minimal voltage drop
  • 50 cm ribbon layout keeps cable routing tidy inside the case
  • Red plug marks PSU end, black plug marks GPU end for error-free connection
  • Compatible with Anatek NP, TP and Zun series modular power supplies

Specifications

No published specifications for this item yet.

Questions about this item

Does the 6-pin to dual 6+2-pin splitter ribbon cable come with any extra connectors or mounting hardware?

The cable is supplied as a single 18AWG ribbon assembly with a red 6-pin PSU plug and two black 6+2-pin GPU heads; no additional connectors or hardware are included.

When should I use this 50 cm 18AWG splitter versus a longer or thicker-gauge alternative?

Choose this 50 cm 18AWG splitter when the PSU 6-pin port sits close to the graphics card and the card needs two 8-pin inputs; longer runs or higher current draws may need a heavier gauge.

What does the 18AWG rating mean for real-world power delivery to my graphics card?

An 18AWG conductor at 50 cm can safely carry the current required by a typical dual 8-pin graphics card without excessive voltage drop or heating.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Internal Power Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.