We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue braided 1.5m aux cable with 3.5mm plug and bare wire ends

Ruth's sister

Ruth's sister 3.5mm 1.5m replacement aux cable for HyperX Cloud II Core Pro Cloudx Stinger Revolver S

SKU CH-354N-APXP9

A 1.5 m oxygen-free copper replacement cable with a 3.5 mm plug for compatible HyperX headsets

  • Restores audio with 3.5mm male plug for HyperX headsets
  • 5m oxygen-free copper cable delivers clear signal transmission
  • Braided rope jacket resists wear for long-term durability
  • Four-wire design supports stereo sound and microphone function
  • Direct replacement for damaged Cloud II, Core, Stinger, Revolver S cables

Replacement cable for HyperX headsets

This 3.5mm aux cable is built as a direct repair part for Kingston HyperX Cloud II Core Pro Cloudx Stinger Revolver S wired gaming headsets. It replaces a worn or damaged original lead so the headset returns to full audio and microphone function. The oxygen-free copper conductors and braided jacket are chosen for durability in daily use. Gamers podcasters and anyone who relies on these specific models can keep working without sourcing a whole new headset.

1.5 metre length with bare-wire ends

The cable measures approximately 1.5 metres giving enough reach for desktop and console setups. Four colour-coded conductors — blue for left red for right green for microphone and copper for common ground — terminate in bare wires ready for soldering to the headset PCB. The 3.5mm male plug connects to the source device. No inline controls or additional shielding are included so the cable suits straightforward stereo and mono mic wiring only.

Bare-wire termination for solder repair

The package supplies a single audio cable with no connectors on the headset side. This means the user must solder the four leads to the internal speaker and microphone pads which requires basic soldering skill and tools. No heat-shrink tubing flux or instruction sheet is provided. Builders who need a plug-and-play solution or lack soldering equipment will not be able to use this cable as-is.

Highlights

  • Restores audio with 3.5mm male plug for HyperX headsets
  • 5m oxygen-free copper cable delivers clear signal transmission
  • Braided rope jacket resists wear for long-term durability
  • Four-wire design supports stereo sound and microphone function
  • Direct replacement for damaged Cloud II, Core, Stinger, Revolver S cables

Specifications

No published specifications for this item yet.

Questions about this item

Will the 1.5 m cable reach my PC if the headset jack is on the front panel?

The cable is 1.5 m long with a straight 3.5 mm male plug, which typically reaches a front-panel jack on a mid-tower case when the headset is worn.

How can I verify the microphone wire is connected correctly after soldering?

Plug the 3.5 mm jack into a device, speak into the headset mic, and confirm the green (mic) and copper (ground) wires carry a clear voice signal without static.

Does the package include heat-shrink tubing or a soldering iron for the bare-wire ends?

The box contains only the 1.5 m replacement audio cable with blue, red, green and copper wires exposed; heat-shrink, solder and tools must be sourced separately.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.