We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green printed circuit board with electronic components and solder pads

Ruth's sister

Ruth's sister 2-Way Speaker Crossover Board international power cord

SKU CH-M1M0-K1FEP

A 2-way crossover board that separates audio signals into treble and bass for DIY speaker builds

  • 2-way crossover separates treble and bass signals for clearer sound
  • High-quality capacitors and wire-wound resistors handle high power without burnout
  • DIY-friendly PCB layout with precise cutouts simplifies soldering
  • Professional frequency divider improves overall Hi-Fi speaker performance
  • Treble routed to tweeter, bass to subwoofer for balanced audio

DIY Speaker Crossover Module

This two-way frequency divider board separates a full-range audio signal into dedicated treble and bass paths for tweeter and woofer drivers. It is intended for hobbyists building or repairing passive speaker cabinets who need a ready-made crossover circuit without designing their own filter topology.

Verify Driver Impedance and Power Handling

Before ordering, confirm that your tweeter and woofer impedance ratings match the board's design expectations and that their combined power handling suits your amplifier output. The module has no adjustable components, so the crossover frequency and slope are fixed and cannot be tailored to different driver parameters.

Ceramic Resistors and Metal-Film Capacitors

The board uses wire-wound ceramic resistors and metal-film capacitors rated for sustained high-power operation without thermal failure. Its printed circuit layout provides labelled solder pads for input, tweeter, and woofer connections, allowing straightforward hand-wiring in a home workshop.

Highlights

  • 2-way crossover separates treble and bass signals for clearer sound
  • High-quality capacitors and wire-wound resistors handle high power without burnout
  • DIY-friendly PCB layout with precise cutouts simplifies soldering
  • Professional frequency divider improves overall Hi-Fi speaker performance
  • Treble routed to tweeter, bass to subwoofer for balanced audio

Specifications

No published specifications for this item yet.

Questions about this item

What components are included with the crossover board and is any solder or wire supplied?

The board arrives as a bare printed circuit assembly with surface-mount inductors, ceramic wire-wound resistors and metal-film capacitors already fitted. No solder, hook-up wire, terminals or enclosure are included — these must be sourced separately.

The listing describes a single 2-way board; are there alternative crossover frequencies or power ratings to select from?

Only one version is offered: a fixed two-way network with preset crossover points for treble and bass. No selectable frequency options, alternative slopes or higher-power variants are listed.

Once soldered into a speaker cabinet, what audible effect does the board’s stated frequency division produce?

The network routes high frequencies to the tweeter and low frequencies to the woofer, giving clearer treble and tighter bass compared with running both drivers full-range.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.