We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pack of ten small joystick potentiometers with metal shafts and plastic bases

Ruth's sister

Ruth's sister 10pcs 3D Analog Joystick Potentiometers Micro Switch Replacement Repair Parts for Controller

SKU CH-X20B-PCHCS

Pack of ten 3D analog joystick potentiometers with micro switches for controller repair

  • 10-piece pack restores multiple controllers
  • 2K3 resistance fixes stick drift and dead zones
  • Metal and ABS construction extends component lifespan
  • 3 cm diameter fits standard controller modules
  • Solder installation returns precise analog response

Pack of 10 replacement joystick potentiometers

This pack contains ten 3D analog joystick potentiometers with integrated micro switches. They are designed as repair parts for game controllers suffering from stick drift, dead zones or centring issues caused by long-term wear. The components use a 2K3 resistance value and three-pin layout to match the original sensor specifications. Each unit combines metal and ABS plastic construction for durability during repeated actuation.

Low-power passive components

As passive rheostats, these potentiometers draw no power themselves and add no thermal load or audible noise to the controller. They operate within the existing low-voltage logic circuit of the gamepad, so installation does not change battery life or require additional cooling. Normal use simply restores the original electrical characteristics of the analog stick assembly.

Solder-required installation

Each potentiometer measures approximately 1.3 cm in diameter and features three through-hole pins for PCB mounting. Replacement demands a soldering iron and fine-gauge solder, so the repair is suited to users comfortable with basic electronics work. The pack of ten provides spares for multiple controllers or repeat attempts, but buyers without soldering equipment or surface-mount rework skills should note the installation requirement.

Highlights

  • 10-piece pack restores multiple controllers
  • 2K3 resistance fixes stick drift and dead zones
  • Metal and ABS construction extends component lifespan
  • 3 cm diameter fits standard controller modules
  • Solder installation returns precise analog response

Specifications

No published specifications for this item yet.

Questions about this item

How do I solder the 3-pin 2K3 potentiometer onto the controller board?

Desolder the old stick, align the new 1.3 cm diameter potentiometer's three pins with the PCB pads, then flow solder with a fine-tip iron and thin gauge wire.

Will the metal-and-ABS plastic potentiometer wear out again?

The metal-and-ABS construction resists wear, but after years of heavy use the 2K3 resistive track can develop dead zones again.

At what point does the 2K3 resistive track show drift during long sessions?

Extended play can heat the 2K3 track enough to shift the centre voltage, causing drift before the part physically wears out.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.