We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three red SATA cables with locking latches, 19 inch length

RIITOP

RIITOP SATA Cable III 3-pack 6Gbps locking latch 19 inch red

SKU CH-D5W5-GR8KQ

Three 19-inch red SATA 3.0 cables with locking latches for 6 Gbps internal drive connections

  • ColorRed
  • 6 Gbps transfer speed with SATA 3.0 support
  • Locking latch on each end secures the connection
  • 19 inch length fits standard case layouts
  • Three cables included for multiple drive installs
  • Backwards compatible with SATA I and SATA II

Three-cable SATA III kit

This pack supplies three red SATA III cables, each 50 cm long, for linking motherboards or host controllers to internal hard drives, SSDs or optical drives. The locking latch on both ends secures the connection against vibration. The cables carry data only; a separate power lead is still required for each drive.

6 Gbps transfer ceiling

Revision 3.0 raises the theoretical ceiling to 6 Gbps, twice the SATA II rate, while remaining backward compatible with SATA I and SATA II ports. Actual throughput will match the slowest device in the chain, so older drives will run at their own rated speed.

50 cm reach per cable

At 50 cm (1.64 ft) each cable suits typical mid-tower layouts but may fall short in full-tower builds or when routing behind a motherboard tray. Builders needing longer runs or angled connectors should look elsewhere.

Highlights

  • 6 Gbps transfer speed with SATA 3.0 support
  • Locking latch on each end secures the connection
  • 19 inch length fits standard case layouts
  • Three cables included for multiple drive installs
  • Backwards compatible with SATA I and SATA II

Specifications

ColorRed

Questions about this item

Will the locking latches on these 19 inch cables wear out after repeated drive swaps?

The latches are moulded into each connector end to stay engaged during vibration or cable routing; they are rated for the normal insert-and-remove cycles of internal SATA connections.

What caps the transfer speed when these cables run at full 6 Gbps all day?

The SATA 3.0 interface tops out at 6 Gbps, so the connected drive or controller becomes the limiting factor once that ceiling is reached.

Do the red cables add any heat or power draw inside a case that runs continuously?

They carry only data signals and draw negligible power from the host port, so they contribute no measurable heat to the chassis.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.