Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Two-colour 30 AWG silicone-insulated stranded tinned-copper wire kit, 10 ft red and 10 ft black, rated 600 V from -60 °C to 200 °C
This RCA kit supplies two 10 ft lengths of 30 AWG stranded tinned copper wire in red and black jackets. The 11-strand 0.08 mm conductors are insulated with flexible silicone rubber rated for 600 volts. It suits hobbyists wiring models, lamps, instruments or low-voltage appliances where colour-coded polarity matters.
Silicone insulation remains pliable from -60 °C up to 200 °C without cracking or stiffening. The wire carries no active components so it generates no noise and draws no power itself. Low impedance and tight twisting reduce signal loss in the circuits it connects.
Each spool measures roughly 7.8 x 5.5 x 0.3 inches and weighs very little, so storage is simple. The 0.8 mm outer diameter passes through tight grommets or chassis holes. No special tools are needed beyond a stripper and soldering iron; the tinning makes solder joints quick and reliable. Builders needing heavier gauge or shielded cable should look elsewhere.
| Brand | RCA |
|---|---|
| Model | SW30A11008F10C2 |
| Color | Black |
| Length | 50 ft. |
| Connector Number | 2 |
| Specifications | 30 gauge silicone wire 10ft and 10ft, BNTECHGO, 10, feet, 30, silicone wire red and black, 11, silicone rubber + copper, 2, SW30A11008F10C2, 7.8 L x 5.5 W x 0.3 H inches |
| Wire Gauge | 14 AWG |
| Conductor | Copper Conductor |
| Features | 30 gauge silicone wire 10ft and 10ft, 30, silicone rubber + copper, silicone wire red and black, 2, 11, BNTECHGO |
Use a precision stripper set for 30 AWG to avoid nicking the 11 tinned copper strands; the pre-tinned surface wets quickly at normal soldering temperatures, so apply heat briefly and feed solder to the joint, not the iron.
The silicone rubber jacket is rated from -60 °C to 200 °C and resists cracking, but repeated sharp bends at the same point or prolonged exposure above 200 °C will eventually harden the insulation and require replacement of that section.
With 11 strands of .08 mm tinned copper at 30 AWG, resistance is roughly .1 Ω per foot; at 600 V rating the insulation handles high voltage, but for low-voltage DC the 10 ft length reaches noticeable drop around 2–3 A continuous, so keep sustained loads below that level.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?