Peerless Industrial Group
Peerless Industrial Group Tire Chains Single Bus & RV V-Bar PK2 QG2821
$67.99
0.00081572BTC
In stock
Power Circuit Probe Tester 6V/12V/24V DC Automotive Electrical System Tool Blue
Tests 3.5 V to 36 V DC circuits with LCD readout, polarity LEDs, buzzer alert and piercing probe
- Features1*circuit tester, 1*instruction manual, Battery Powered, fal
- Sports Team1 Piece
- Accurate voltage readings within ±0.2 V margin
- Tests 3.5 V to 36 V DC circuits
- Built-in LED light for dark-area testing
- Audible buzzer warns of overload or reverse polarity
- Sharp probe pierces wire insulation for direct contact
What this tool does
A multifunction automotive circuit tester for 6 V, 12 V and 24 V DC systems. It combines a backlit LCD voltmeter, continuity beeper, polarity LEDs and a piercing probe so technicians can locate shorts, open circuits, bad grounds and voltage drops without repeated disassembly.
Who it suits and who it does not
Ideal for professional mechanics and serious DIYers who need live voltage read-outs, audible overload alerts and one-handed polarity indication in dark engine bays. Not suited for buyers who require AC mains testing, data-logging capability or a non-contact voltage detector.
The spec that decides fit
Measures DC voltage from 3.5 V to 36 V with a stated accuracy of ±0.2 V. If your diagnostic routine demands resolution tighter than that figure, this tester will not meet the requirement.
Highlights
- Accurate voltage readings within ±0.2 V margin
- Tests 3.5 V to 36 V DC circuits
- Built-in LED light for dark-area testing
- Audible buzzer warns of overload or reverse polarity
- Sharp probe pierces wire insulation for direct contact
Specifications
| Brand | Ansbell |
|---|---|
| Features | 1*circuit tester, 1*instruction manual, Battery Powered, false |
| Sports Team | 1 Piece |
Questions about this item
How do I connect the power clips to the battery and which probe mode do I select for voltage testing?
Clamp the red clip to the battery positive and the black clip to the negative, then press Up to drive the probe with positive power or Down for negative; the LCD will show live voltage from 3.5 V to 36 V.
What part of the tester will need replacement after repeated wire piercing?
The long sharp probe tip can dull or bend after many piercings, so keep a spare probe or replacement tip on hand for continued accurate contact.
At what voltage does the overload buzzer activate during a sustained short-circuit test?
The buzzer sounds instantly when an overload is detected while probing, protecting both the battery and the tester during continuity checks.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
