We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Braided black and white PSU extension cable kit with 24-pin ATX, dual EPS and PCI-E connectors, 30cm length

PISKEKAT

PISKEKAT Server Rack PSU Extension Cable Kit 16AWG 30cm Dual EPS Black White

SKU CH-2DFP-4NW43

A 30 cm sleeved extension kit with one 24-pin ATX, two 4+4-pin EPS and three 6+2-pin PCIe cables in 16 AWG wire

  • TypeServer
  • Dual EPS cables enable two-CPU motherboard support
  • 16AWG UL1015 wire handles higher current without overheating
  • Gold-plated GPU terminals resist wear from repeated insertion
  • Nylon braid with four combs per cable keeps routing tidy
  • 30cm length suits compact server rack builds

Dual-CPU EPS Extension Kit

This kit adds 30 cm of reach to every primary power cable in a dual-processor server build. It includes one 24-pin ATX extension, two 4+4-pin EPS extensions and three 8-to-6+2-pin PCIe extensions, all terminated with gold-plated contacts. The 16 AWG UL1015 conductors carry higher current without overheating. Nylon-braided sleeving and four combs per cable keep routing tidy inside deep rackmount chassis.

Replaces Short OEM Leads

Stock PSU cables often fall short when the power supply sits at the rear of a 4U enclosure and the motherboard spans the full depth. These extensions bridge that gap without daisy-chaining adapters, so voltage drop stays minimal even under sustained dual-CPU loads. The upgrade is worth it whenever the factory leads cannot reach both EPS sockets and the GPU power connectors simultaneously.

Fits Modular PSU Looms

Each extension plugs directly into the existing modular cables of the power supply, so no re-pinning or crimping is required. The flexible braid bends around drive cages and backplane brackets while the combs lock wire spacing, freeing the installer from zip-tie grids. Builders who need longer runs than 30 cm or non-standard pinouts will need a different solution.

Highlights

  • Dual EPS cables enable two-CPU motherboard support
  • 16AWG UL1015 wire handles higher current without overheating
  • Gold-plated GPU terminals resist wear from repeated insertion
  • Nylon braid with four combs per cable keeps routing tidy
  • 30cm length suits compact server rack builds

Specifications

TypeServer

Questions about this item

What clearance does the 30 cm sleeved length need inside a server rack?

The 30 cm extensions add minimal bulk; route them alongside existing PSU cables and use the supplied combs to keep the nylon braid flat against the chassis.

Which connector goes on first when fitting the dual 4+4 pin EPS cables to a twin-CPU board?

Plug each 4+4 pin block into the motherboard EPS sockets before seating the 8-pin ends into the PSU, otherwise the keyed tabs can catch.

When should the gold-plated PCI-E terminals be inspected or the combs replaced?

Check the gold pins for oxidation during any major hardware swap; the nylon combs only need replacement if clips break or cables start to sag.

New to this? Buying server hardware with crypto — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.