We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two 1ft RG8x coaxial cables with nickel PL-259 male connectors

PISKEKAT

PISKEKAT RG8x PL259 Coaxial RF Cable 1ft 2-Pack 50 ohm 17AWG

SKU CH-6CSD-1CHQJ

Two 12-inch 50 ohm PL-259 jumper cables with 17AWG RG8x conductors and 128-strand aluminum braid for low-loss RF links

  • TypeOther
  • Low-loss signal transmission with 128 x 0.12 mm aluminum braid shield
  • Thicker 17 AWG pure copper conductor outperforms standard RG58
  • UHF PL-259 male-to-male connectors with nickel-plated, fully molded ends
  • 50 ohm impedance matches CB radio, analyzer, and SWR meter requirements
  • Two 12-inch cables included for flexible ham radio and Jeep Wrangler setups

CB Ham Radio Jumper Cable

This 1 ft coaxial cable connects CB radios, antenna analysers, tuners, switches, monitors, dummy loads and SWR meters using UHF PL-259 male plugs on both ends. The nickel-plated connectors are fully moulded for strain relief and consistent contact. It is also suited to Jeep Wrangler CB installations where a short, low-loss link is required.

50 Ohm RG8x Low-Loss Construction

The cable uses a 17 AWG pure copper centre conductor and a braid shield of 128 strands of 0.12 mm aluminium wire to achieve low attenuation at 50 ohms. RG8x is a step up from standard RG-58 coax and is recommended for higher-powered applications. The thicker conductor and dense shielding preserve signal integrity across the short jumper length.

Two-Pack Capacity for Dual Connections

Supplied as a 2-pack, the cables provide spare or parallel links for equipment that needs two coaxial paths such as a radio and an analyser simultaneously. Each 1 ft length limits reach to adjacent devices on a bench or in a vehicle console. Runs that exceed this distance or require a different connector type will need alternative cable assemblies.

Highlights

  • Low-loss signal transmission with 128 x 0.12 mm aluminum braid shield
  • Thicker 17 AWG pure copper conductor outperforms standard RG58
  • UHF PL-259 male-to-male connectors with nickel-plated, fully molded ends
  • 50 ohm impedance matches CB radio, analyzer, and SWR meter requirements
  • Two 12-inch cables included for flexible ham radio and Jeep Wrangler setups

Specifications

TypeOther

Questions about this item

Should I pick the 1ft 2-pack or a different length?

The listing supplies two 12-inch PL-259 jumpers in one pack. If your antenna analyser, SWR meter or dummy load sits closer than 12 inches, the cables will reach; otherwise you will need a longer pair.

What does the 50 ohm rating mean once the cable is connected?

The 50 ohm impedance matches standard CB and ham radio gear, so the RG8x jumper passes the signal without reflection when used with a 50 ohm antenna, analyser or meter.

How does the PL-259 interface limit what I can connect?

Each end carries a UHF PL-259 male plug, so the cable only mates with PL-259 female ports — common on CB radios, antenna analysers, tuners, dummy loads and SWR meters.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.