Phobya
Phobya Thermal Pad 1.5W/mK 15x15x1.0mm 1pc 17011
A 1.5 W/mK thermal pad measuring 15 by 15 by 1.0 mm that fills gaps on coolers, VRAM or VRM modules and stays in place with a lightly tacky surface
- FeaturesThese thermal pads are perfectly suited to equalize height d
- Equalises cooler gaps with flexible 1.0 mm pad
- Low hardness adapts to surfaces at minimal pressure
- Covers microscopic scratches up to visible imperfections
- Slight tack holds pad in place without slipping
- Cut to size for VRAM, VRM or chipset use
Phobya Thermal Pad 1.5 W/mK
The Phobya thermal pad uses a 1.5 W/mK conductivity rating to transfer heat from VRAM, VRM or chipset components. Its flexible, low-hardness structure conforms to uneven surfaces and microscopic scratches at low mounting pressure. A slightly tacky surface holds the pad in place once the protective foil is removed.
Replaces dried or missing factory pads
Swap out hardened original pads on graphics cards or motherboards when temperatures rise or contact becomes uneven. The jump is worth it whenever the original material has lost compliance or was too thin to bridge a gap. The 15 x 15 mm sheet can be trimmed to fit any smaller die or module.
Suits DIY coolers and repair kits
Builders who need a single 1.0 mm sheet for a targeted repair or custom loop will find the size convenient. Buyers looking for higher conductivity for dense GPU cores or multi-pad kits should look at something else.
Highlights
- Equalises cooler gaps with flexible 1.0 mm pad
- Low hardness adapts to surfaces at minimal pressure
- Covers microscopic scratches up to visible imperfections
- Slight tack holds pad in place without slipping
- Cut to size for VRAM, VRM or chipset use
Specifications
| Brand | Phobya |
|---|---|
| Model | 17011 |
| Part Number | 17011 |
| Features | These thermal pads are perfectly suited to equalize height differences and uneven spots on coolers and cooled elements. The very flexible structure and low hardness allow great adaptivity to the cooling surface even at low contact pressures. The thermal pad equalizes the effect of irregularities from microscopic scale to visible scratches etc. |
Questions about this item
Will the 15 mm square pad cover my VRAM chips?
Each pad measures 15 mm by 15 mm. Measure your chips first; you can trim the pad with scissors if a smaller piece is needed.
Which side of the pad goes down first?
Peel the protective foil off one face, place that sticky side on the component, then remove the second foil before lowering the heatsink.
How often should I replace the 1.5 W/mK pad?
Replace it whenever you disassemble the cooler or if temperatures rise noticeably; the pad is not reusable once compressed.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00113914BTC
In stock
