We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three black 3-pin fan extension cables coiled together, each 80cm long

Phobya

Phobya 3-Pin Fan Extension Cable 80cm Black 3-Pack

SKU CH-GHJF-S4XT2

Three 80 cm 3-pin fan extension cables extend short leads to motherboard headers and convert 4-pin PWM fans to 3-pin operation

  • ColorBlack
  • FeaturesThis is a fantastic fan extension kit for Phobya that should
  • Three 80 cm extensions reach distant headers
  • 3-pin connectors accept 4-pin PWM fans
  • Black sleeving keeps multi-fan builds tidy
  • Unshielded design enables voltage-control conversion
  • Pack of 9 cables covers complex loops

Three 80 cm extensions for multi-fan builds

This pack supplies three 3-pin fan extension cables, each 80 cm long, so builders can reach distant motherboard headers without stretching stock leads. The black sleeving keeps the looms tidy inside windowed cases. They suit any system that needs extra fan length beyond the factory cables. The unshielded connectors also let a 4-pin PWM plug run on a 3-pin header when PWM control is not required.

Replaces short stock leads when headers are far away

Use these when the standard fan tails cannot reach the board in full-tower or dual-chassis layouts. The jump is worth it whenever cable routing forces a detour behind trays or through grommets that eat up slack. They do not add PWM functionality, so fans that rely on 4-pin speed control will run at fixed voltage instead.

Push-fit connectors need no tools

Each end presses onto the header or fan by hand; no crimping or soldering is involved. The only common snag is reversing the polarity — match the tab on the plug to the notch on the header before pushing. Because the connectors are unshielded, a 4-pin fan will lose its tachometer wire and report zero RPM to the BIOS.

Highlights

  • Three 80 cm extensions reach distant headers
  • 3-pin connectors accept 4-pin PWM fans
  • Black sleeving keeps multi-fan builds tidy
  • Unshielded design enables voltage-control conversion
  • Pack of 9 cables covers complex loops

Specifications

BrandPhobya
ModelADIB009ZMOYF6
ColorBlack
FeaturesThis is a fantastic fan extension kit for Phobya that should be purchased for any multi-fan build. Running out of a very simple, staple part during your build is incredibly frustrating; with this kit you'll never have to worry about fan tails being long enough for motherboard headers! Three, 80cm 3-Pin Fan extensions are included. Since the connectors are unshielded, these cables will also convert 4-Pin PWM to 3-Pin Fan.

Questions about this item

How long is each 3-pin fan extension cable in the pack?

Each cable measures 80cm, giving extra reach from fan to motherboard header.

How do I connect a 4-pin PWM fan using these 3-pin extensions?

Plug the 4-pin fan into the extension's female end; the unshielded connector carries power and tach signal while the PWM pin stays unused.

When would I need to replace these extension cables?

Replace them if the pins bend, the insulation frays, or the connector no longer grips the header securely.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.