We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Pannet

Pannet UTPSP7BLY Category-6 network ethernet cable 7 ft black

SKU CH-2YPZ-GQ0WV

Category 6 patch cable with RJ-45 connectors on both ends, 7 ft long, black jacket with clear boots

  • Cat6
  • Length7 ft.
  • Category 6 performance supports gigabit speeds
  • 7 ft length suits short rack or desk runs
  • Clear strain-relief boots protect connector latch
  • Copper conductors meet ANSI/TIA-568 and ISO 11801
  • Black jacket with RJ-45 plugs on both ends

Category-6 patch cord for copper networks

This seven-foot Category-6 patch cord uses eight copper conductors terminated with RJ-45 male connectors on both ends. It carries a clear strain-relief boot on each plug and meets ANSI/TIA/EIA-568-B.2-1, ISO 11801, IEEE 802.3, ANSI/TIA-968-A and IEC 60603-7. The black jacket suits standard indoor routing.

Fits any Gigabit Ethernet port with an RJ-45 jack

The cord plugs directly into switches, routers, patch panels or network interface cards without adapters. Its pre-terminated ends free the installer from crimping tools and connector stock while the clear boots protect the latch during repeated insertion and removal cycles.

Suits installers who need a certified seven-foot

Builders requiring a different length, a crossover pinout, shielded construction or outdoor-rated jacketing should select another cable. The fixed seven-foot reach also limits use in runs that demand longer or shorter segments.

Highlights

  • Category 6 performance supports gigabit speeds
  • 7 ft length suits short rack or desk runs
  • Clear strain-relief boots protect connector latch
  • Copper conductors meet ANSI/TIA-568 and ISO 11801
  • Black jacket with RJ-45 plugs on both ends

Specifications

BrandPanduit
Cat6
Length7 ft.

Questions about this item

What is the maximum cable length before signal loss limits performance?

The cable is 7 ft long and meets ANSI/TIA/EIA-568-B.2-1 and ISO 11801 standards for Category 6 patch cords.

Does the cable generate heat or noise during continuous network traffic?

No, it is a passive copper patch cord with no active components, so it produces no heat or noise.

What devices or ports are needed to use this cable?

It requires two RJ-45 network ports, such as those on a router, switch, PC or patch panel.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.