We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 40mm square fan with four-pin connector

OEM Industries

OEM Industries U40R05MS1A7-57A07A 40mm 4-pin CPU cooler

SKU CH-TEKG-8R6DH

A 40 mm square fan with maglev bearing, 4-pin PWM control and 5 V 0.08 A draw fits Xbox One Kinect 2.0 cooling

  • ColorBlack
  • TypeFan only
  • Fan Size40mm
  • Power Connector4 Pin
  • LEDNo
  • Compact 40 mm square frame fits tight builds
  • Maglev bearing reduces friction for quiet operation
  • 4-pin PWM connector enables precise speed control
  • Low 5 V 0.08 A draw limits power consumption
  • Direct replacement for Xbox One Kinect 2.0 cooler

Nidec 4015 40 mm 4-pin case fan

The Nidec 4015 U40R05MS1A7-57A07A is a square 40 mm by 15 mm fan with a 4-pin power connector that runs on 5 V at 0.08 A. It uses a maglev bearing and has no LED lighting. The part is listed as a cooler for the Xbox One Kinect 2.0.

Suits repairs that need an exact 5 V 4015

This fan fits devices designed for the 4015 form factor and a 5 V four-wire header. Builders whose systems only provide a different voltage header, or who require a taller heatsink assembly, cannot use this part.

5 V 0.08 A 4-pin power specification

The cooler draws 0.08 A from a 5 V supply through its 4-pin connector. That voltage and current rating is the single figure that determines whether the fan will operate in a given device.

Highlights

  • Compact 40 mm square frame fits tight builds
  • Maglev bearing reduces friction for quiet operation
  • 4-pin PWM connector enables precise speed control
  • Low 5 V 0.08 A draw limits power consumption
  • Direct replacement for Xbox One Kinect 2.0 cooler

Specifications

ModelU40R05MS1A7-57A07A
ColorBlack
TypeFan only
Fan Size40mm
Power Connector4 Pin
LEDNo

Questions about this item

Does my motherboard need a 4-pin PWM header to power the 40mm Nidec U40R05MS1A7-57A07A cooler?

Yes, the cooler uses a 4-wire 4-pin connector that requires a matching 4-pin PWM header on the motherboard or controller for power and speed control.

Can the 5 V 0.08 A Maglev fan run on an older 3-pin header if I use an adapter?

A 3-pin header supplies only three wires; the fourth PWM wire would be left unconnected, so speed control is lost and the fan may run at a fixed voltage instead of responding to PWM signals.

How can I confirm the Maglev bearing fan is spinning correctly after installation?

Connect the 4-pin header, power on the system, and verify in BIOS or monitoring software that the fan reports an RPM value above zero and responds to PWM duty-cycle changes.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.