We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black Molex-to-SATA power cables, 20 cm each

NShi

NShi 2 x Molex 4-pin to SATA 15-pin Power Adapter Cable 20cm

SKU CH-N5HM-GMW2R

Converts one 4-pin Molex connector into two 15-pin SATA power plugs using 20 cm 18AWG copper cable for drives and optical devices

  • TypeAdapter/Converter
  • Length< 12 ft.
  • Connector Number1
  • Connector DetailSATA 15-pin Male, SATA Male, SATA Female, 1:1
  • Terminal GenderSATA 15-pin Male, SATA Male, SATA Female
  • SpecificationsNo, Adapter/Converter, SATA 15-pin Male, SATA Male, SATA Fem
  • Converts one Molex connector into two SATA power ports
  • 20 cm cable keeps wiring tidy inside the case
  • 18 AWG copper conductors deliver reliable 5 V power
  • Supports hard drives, SSDs and optical drives
  • Thermoplastic insulation protects against heat and wear

Power adapter for legacy PSUs

This cable converts a single four-pin Molex connector into two SATA fifteen-pin power plugs. It lets older power supplies run modern hard drives, solid-state drives or optical drives without replacing the PSU. Builders upgrading storage in vintage systems will find it a direct fit.

One Molex to two SATA power connectors

Each adapter splits one male four-pin Molex into a pair of female fifteen-pin SATA power ports. The specification is the decisive detail: one legacy output powers two SATA devices simultaneously. Buyers who need to run more than two drives from one Molex must look for a different splitter.

Twenty-centimetre 18 AWG copper leads

The 20 cm length keeps cable clutter low inside tight chassis while the 1007 18 AWG copper conductors handle the five-volt rail reliably. No extra software or mounting hardware is included; the adapter is ready to plug in and power the connected drives immediately.

Highlights

  • Converts one Molex connector into two SATA power ports
  • 20 cm cable keeps wiring tidy inside the case
  • 18 AWG copper conductors deliver reliable 5 V power
  • Supports hard drives, SSDs and optical drives
  • Thermoplastic insulation protects against heat and wear

Specifications

BrandGE
ModelDoes Not Apply
TypeAdapter/Converter
Length< 12 ft.
Connector Number1
Connector DetailSATA 15-pin Male, SATA Male, SATA Female, 1:1
Terminal GenderSATA 15-pin Male, SATA Male, SATA Female
SpecificationsNo, Adapter/Converter, SATA 15-pin Male, SATA Male, SATA Female, 1/2 ft, 5 V, 1:1, Unbranded/Generic, Does Not Apply, China
FeaturesNo

Questions about this item

How much power can the 18AWG conductors on this 20cm adapter actually deliver to a pair of SATA drives?

The 18AWG copper wires are rated for the standard 5 V rail and can supply both connected drives from a single Molex source without voltage drop over the short 20cm run.

What does the 15-pin SATA connector on this cable provide that a 7-pin data cable does not?

The 15-pin connector carries the 5 V power rail needed by SATA hard drives, SSDs and optical drives, while a 7-pin cable only handles data signals.

Will the 20cm length reach from a bottom-mounted PSU to a top 5.25-inch drive bay in a full-tower case?

At 20cm the cable is designed for tight internal routing — such as stacking two drives in the same cage — and will not span the full height of a large tower.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.