Innovation First, Inc.
Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
$72.99
0.00087698BTC
In stock
No Sew
No Sew HCFeng USB 2.0 A Male 2-Pin Bare Wire Cable with ON/Off Switch 1.5m 2-Pack
Two USB 2.0 A male to bare-wire cables with built-in on/off switches for 5 V–12 V DC power-only connections
- Compatible Phone Manufacturercarc
- Compatible Phone Modelcarc, car-c
- ColorBlack
- AdapterUSB
- Length3.3 mils
- HDMI PortUSB Type A
- Built-in ON/OFF switch lets you power devices without unplugging
- 5 m length gives flexible placement for dash cams or LED strips
- 22 AWG copper conductors carry up to 5 A at 12 V DC
- Two cables per pack provide spares or dual-device setups
- Bare-wire ends enable direct soldering or terminal connections for DIY projects
USB 2.0 A Male power cable with switch
This 2-pack supplies two 1.5 metre cables that end in bare 22 AWG wires instead of a standard device plug. Each cable carries a USB 2.0 Type-A male connector rated for 5 V to 12 V output at up to 5 A. The integrated on/off button lets you cut power without unplugging the cable from the host port. The product is sold new and is intended solely for low-voltage DC power delivery.
Integrated on/off switch changes daily use
The built-in switch removes the need to physically disconnect the USB plug when powering down a dash cam, LED strip, USB fan or similar peripheral. Red wire marks positive and black wire marks negative, simplifying DIY soldering or terminal-block connections. Because the cable carries no data lines, it cannot be used for file transfer, firmware updates or any communication with the host device.
Simple install but polarity must be checked
Stripping the 22 AWG pigtail and matching red to positive and black to negative is the only assembly step; no drivers or configuration are required. The most common error is reversing the two conductors, which can damage the connected device. Users who need data sync or a standard USB device connector should choose a different cable type.
Highlights
- Built-in ON/OFF switch lets you power devices without unplugging
- 5 m length gives flexible placement for dash cams or LED strips
- 22 AWG copper conductors carry up to 5 A at 12 V DC
- Two cables per pack provide spares or dual-device setups
- Bare-wire ends enable direct soldering or terminal connections for DIY projects
Specifications
| Brand | HCFeng |
|---|---|
| Series | HC-DC2P-AJ02 |
| Model | carc, car-c |
| Compatible Phone Manufacturer | carc |
| Compatible Phone Model | carc, car-c |
| Color | Black |
| Adapter | USB |
| Length | 3.3 mils |
| HDMI Port | USB Type A |
| Output Volt | 12 volts_of_direct_current |
| Output Amp | 5 amps |
| Support Volt | 12 volts_of_direct_current |
| Wire Gauge | Low Voltage |
| Specifications | Low Voltage, 4.9ft/1.5m, USB, USB Type A, 3.3, mils, 5 amps, 2, black, Male-to-Male, car-c, HF-USB-SB02, HF-USB-SW31 |
| Features | Low Voltage |
Questions about this item
How often does the built-in on/off switch need to be replaced during long-term use?
The supplier describes the switch as wear-resistant and designed for a longer service life, with no scheduled replacement interval mentioned.
What is the first limit reached when the cable runs continuously at its 5-amp rating?
The 22AWG copper conductors are rated for 5 A at 5 V–12 V; sustained loads at that level will hit the wire’s current capacity before any other constraint.
How warm does the cable get when powering a 12 V device all day?
PVC-insulated 22AWG wire carrying up to 5 A will warm slightly, but the low-voltage design keeps heat minimal during continuous operation.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Vertiv
Vertiv 4UTELECOMRKIT 19 in rack mount bracket accessory
- GXT4U Wall Mount Br…
- Mounting Bracket
$70.99
0.00085295BTC
In stock
