We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ultra-slim gray Cat6 ethernet cable with snagless RJ45 connectors, 6 ft

Nippon Labs

Nippon Labs SLCAT6-28-6GY network ethernet cable Cat 6 28 AWG 6 ft Gray

SKU CH-Y1E0-ZAPGJ MPN SLCAT6-28-6GY

A 6 ft Cat 6 patch cable with 28 AWG stranded bare copper, 550 MHz bandwidth, snagless narrow boots and gold-plated RJ45 connectors

  • TypeNetwork Ethernet Cable
  • Cat6
  • Connector A1 x RJ45
  • Connector B1 x RJ45
  • Length6 ft.
  • ColorGray
  • Cat 6 rating supports 550 MHz bandwidth
  • 28 AWG ultra-slim design fits high-density racks
  • Snagless boots protect latch during frequent changes
  • Gold-plated RJ45 contacts resist corrosion
  • Six-foot length suits typical desk-to-switch runs

Slim Cat6 patch cable for dense racks

The 6 ft gray cable uses 28 AWG stranded bare-copper conductors and gold-plated RJ45 connectors on both ends. Its ultra-slim profile fits high-density patch panels and crowded network enclosures. Snagless boots protect the locking tabs during frequent moves. The cable is rated for 550 MHz bandwidth and 10-Gigabit Ethernet.

Thermals noise and power draw in normal use

Passive copper construction produces no heat, noise or power draw of its own. Gold-plated contacts resist corrosion to maintain low contact resistance over time. UTP shielding relies on balanced pair geometry rather than active components. The slim jacket adds minimal airflow restriction inside cabinets.

Sustained load behaviour

Bare-copper conductors keep insertion loss stable during continuous 10-Gigabit traffic. The 550 MHz rating provides headroom above the Cat 6 requirement for extended runs. Snagless boots stay secure under vibration from rack-mounted fans. Stranded wire tolerates repeated re-patching without conductor fatigue.

Highlights

  • Cat 6 rating supports 550 MHz bandwidth
  • 28 AWG ultra-slim design fits high-density racks
  • Snagless boots protect latch during frequent changes
  • Gold-plated RJ45 contacts resist corrosion
  • Six-foot length suits typical desk-to-switch runs

Specifications

BrandNippon Labs
ModelSLCAT6-28-6GY
TypeNetwork Ethernet Cable
Cat6
Connector A1 x RJ45
Connector B1 x RJ45
Length6 ft.
ColorGray
Features28 AWG
550Mhz
UTP
Snagless Ultra Slim Cat6
Shipping weight0.05 kg
Package size197 × 127 × 18 mm

Questions about this item

How do I install the snagless RJ45 connectors without damaging the narrow boot?

Align the RJ45 tab with the port, push straight in until the snagless boot clicks, and pull the cable body — not the boot — when removing it to avoid bending the 28 AWG conductors.

What maintenance will the gold-plated RJ45 contacts and stranded 28 AWG copper need over time?

Wipe the gold-plated contacts with a dry lint-free cloth if they look dull, and avoid sharp bends or repeated tight coiling that can fatigue the stranded 28 AWG copper cores.

At what point does the 550 MHz bandwidth limit appear during sustained 10-Gigabit Ethernet traffic?

The 550 MHz rating caps the usable frequency; sustained 10-Gigabit Ethernet pushes the cable to that limit, so length and connector quality become the first bottlenecks.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.