We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow CAT6 riser cable in pull box, 1000 ft, 23AWG solid copper, 4 twisted pairs, CMR jacket

NavePoint

NavePoint CAT6 Riser CMR 1000 Ft Yellow 23AWG 250 MHz 400 MHz

SKU CH-VK3W-0JV86

Yellow 23 AWG solid bare copper UTP cable rated CMR riser, 1000 ft pull-box with footage markings, tested to 250 MHz and supporting up to 400 MHz bandwidth for Gigabit indoor runs

  • TypeEthernet Crossover Raw
  • ColorYellow
  • CAT6 riser rating meets fire-safety standards for indoor vertical runs
  • 23 AWG solid bare copper conductors deliver lower resistance than CCA alternatives
  • 400 MHz tested bandwidth supports Gigabit Ethernet and PoE applications
  • Foot-marked jacket enables precise custom-length cuts during installation
  • 1000 ft pull-box design prevents tangles and speeds large-scale deployments

Indoor Gigabit Cable Run

This 1000-foot bulk Ethernet cable is built for permanent indoor installations that need Category 6 performance. The CMR riser jacket satisfies fire-safety requirements for vertical runs between floors. Solid 23AWG bare copper conductors deliver reliable conductivity for Gigabit speeds. The yellow jacket and one-foot markings simplify identification and custom-length cuts during installation.

Suitable Installers and Limitations

The cable suits installers wiring offices, homes or equipment rooms for computers, routers, VoIP phones, IP cameras, printers, consoles, extenders, switches and PoE devices. It is not for buyers who need outdoor or direct-burial ratings, shielded constructions for high-EMI environments, or plenum-rated jackets for air-handling spaces. Stranded patch-cord requirements are also outside its scope.

400 MHz Verified Bandwidth

The single specification that decides fit is the tested 400 MHz bandwidth, which exceeds the 250 MHz Category 6 baseline and confirms headroom for Gigabit Ethernet. If the project demands only the minimum 250 MHz CAT6 threshold, this cable still qualifies, but the higher verified margin is the decisive figure for high-bandwidth indoor runs.

Highlights

  • CAT6 riser rating meets fire-safety standards for indoor vertical runs
  • 23 AWG solid bare copper conductors deliver lower resistance than CCA alternatives
  • 400 MHz tested bandwidth supports Gigabit Ethernet and PoE applications
  • Foot-marked jacket enables precise custom-length cuts during installation
  • 1000 ft pull-box design prevents tangles and speeds large-scale deployments

Specifications

BrandNavePoint
TypeEthernet Crossover Raw
ColorYellow

Questions about this item

What jacket rating and diameter suit a riser shaft installation?

The cable carries a CMR riser rating with a 23 AWG solid bare copper construction, approved for vertical runs between floors in commercial buildings.

Which step do installers most often skip when terminating the 4-pair UTP?

Maintaining the pair twists right up to the IDC contacts on a CAT6-rated jack or plug; untwisting too far degrades the 250 MHz verified performance.

When should the 1000 ft pull-box be replaced rather than repaired?

Replace the box if the jacket shows cracks, the footage markers fade, or the cable kinks permanently — any damage that risks the 400 MHz bandwidth headroom.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.