We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White CAT6 riser cable reel, 23 AWG, 5.8 mm diameter, 1000 ft

NavePoint

NavePoint CAT6 CMR Riser UTP 23AWG 550MHz Network Ethernet Cable 1000FT White

SKU CH-PG8T-EK933

Category 6 riser-rated UTP bulk cable with 23 AWG bare copper conductors, 550 MHz bandwidth and 5.8 mm diameter for gigabit networks up to 1000 ft

  • TypeEthernet Crossover Raw
  • ColorWhite
  • Supports gigabit speeds with certified 10/100/1000 Mbps transfer rate
  • CMR riser rating allows safe in-wall and between-floor installation
  • Bare copper conductors ensure reliable signal integrity
  • 23 AWG gauge with 5.8 mm diameter meets ANSI TIA/EIA 568.2 standards
  • 550 MHz bandwidth handles high-bandwidth applications like PoE and IP cameras

Category 6 CMR Riser Cable

NavePoint Category 6 CMR rated UTP bulk Ethernet cable is designed for in-wall and between-floor runs in non-plenum spaces. The 23 AWG bare copper conductors support certified transfer rates of 10, 100 and 1000 Mbps for computers, VoIP phones, IP cameras, printers, gaming consoles and PoE devices.

Thermals Noise and Power Draw

Passive copper construction generates no heat and produces no audible noise during operation. The cable draws no power of its own and adds no thermal load to the installation environment.

Standards Compliance and Length

Meets or exceeds ANSI TIA/EIA 568.2 requirements with a tested bandwidth of 550 MHz. Supplied as a 1000 ft reel in white with a 5.8 mm outer diameter for straightforward pulls through conduit and cable trays.

Highlights

  • Supports gigabit speeds with certified 10/100/1000 Mbps transfer rate
  • CMR riser rating allows safe in-wall and between-floor installation
  • Bare copper conductors ensure reliable signal integrity
  • 23 AWG gauge with 5.8 mm diameter meets ANSI TIA/EIA 568.2 standards
  • 550 MHz bandwidth handles high-bandwidth applications like PoE and IP cameras

Specifications

BrandNavePoint
TypeEthernet Crossover Raw
ColorWhite

Questions about this item

How do I install the 23AWG solid-core cable in walls and between floors without kinking it?

Pull the 5.8 mm riser-rated cable slowly through stud cavities, keeping bends wider than four times the diameter; the CMR jacket is rated for in-wall and floor-to-floor runs but will kink if forced around tight corners.

What maintenance or replacement will the bare-copper conductors need over time?

The solid 23AWG bare-copper conductors require no periodic maintenance; replace only if a link drops below the certified 10/100/1000 Mbps rate or the jacket shows physical damage.

What limit appears first during sustained PoE or gigabit traffic on this 550 MHz Cat6 run?

The 550 MHz bandwidth and 1000 ft length ceiling are reached before the 10/100/1000 Mbps certified rate, so keep installed runs at or under 1000 ft to avoid signal degradation.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.