We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three clear spools of 12 AWG speaker wire 100 ft each 102 strands 0.16 mm CCA

NavePoint

NavePoint 12 AWG In-Wall Speaker Wire 100ft 102 Strand CCA Clear Pack of 3

SKU CH-YSXQ-0JM56

Three 100 ft spools of 12 AWG in-wall speaker wire with 102 strands of 0.16 mm copper-clad aluminium per conductor

  • TypeIn Wall Speaker Wire
  • ColorClear
  • 12 AWG CCA conductors with 102 strands of 0.16 mm for flexible audio runs
  • CL2 rated in-wall jacket meets fire-safety code for residential installations
  • 100 ft spool length gives ample reach for multi-room speaker layouts
  • Clear PVC insulation allows quick visual inspection of wire condition
  • Pack of 3 spools covers front, centre and surround channels in one purchase

NavePoint 12 AWG In-Wall Speaker Wire

NavePoint 12 AWG in-wall speaker wire uses copper-clad aluminium conductors for home, car or office audio installations. Each cable contains two conductors built from 102 strands of 0.16 mm wire. The clear PVC jacket is CL2 rated for in-wall runs. A pack of three spools provides 100 ft per spool.

Sustained signal transmission over long runs

The 12 AWG gauge keeps resistance low across the full 100 ft length, so amplifier power reaches the speakers with minimal loss during extended listening sessions. Stranded construction resists fatigue when the cable is pulled through studs or conduit. Copper-clad aluminium conducts adequately for typical stereo loads while reducing overall weight compared with solid copper.

Verify CL2 rating and conductor material suit

Confirm that your building regulations allow CL2 rated cable for the intended in-wall path. Check that copper-clad aluminium is acceptable for the amplifier and speaker impedance you plan to drive. Ensure the clear jacket colour matches any aesthetic or identification requirements before ordering.

Highlights

  • 12 AWG CCA conductors with 102 strands of 0.16 mm for flexible audio runs
  • CL2 rated in-wall jacket meets fire-safety code for residential installations
  • 100 ft spool length gives ample reach for multi-room speaker layouts
  • Clear PVC insulation allows quick visual inspection of wire condition
  • Pack of 3 spools covers front, centre and surround channels in one purchase

Specifications

BrandNavePoint
TypeIn Wall Speaker Wire
ColorClear

Questions about this item

Will the 12 AWG CCA conductors run warm when driving speakers all day?

The wire uses copper-clad aluminium at 12 AWG with 102 strands of 0.16 mm, so resistance stays low and heat build-up is minimal during extended playback.

What terminals or connectors do I need to terminate the 12 AWG conductors?

You will need banana plugs, spade lugs or bare-wire binding posts that accept 12 AWG; the cable itself is supplied as raw conductor on a spool.

Can I mix this 12 AWG CCA spool with older 16 AWG copper runs in the same system?

Yes — the 12 AWG gauge presents lower resistance than 16 AWG, so the amplifier sees a consistent load; just keep polarity identical on every run.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.