We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
National Instruments GPIB cable Type X2 Rev C 3.28 ft

National Instruments

National Instruments 763061-01 Rev C Type X2 GPIB Cable 3.28 ft

SKU CH-6R10-HDBBH

GPIB Type X2 cable connects instruments over 3.28 ft with Rev C specification

  • Length3.28 ft.
  • 28 ft length keeps bench instruments close
  • New condition guarantees clean contacts and full signal integrity
  • National Instruments branding means factory-tested GPIB compliance
  • Rev C Type X2 design matches specified controller requirements
  • 1 metre metric equivalent simplifies international lab planning

National Instruments GPIB Cable 3.28 ft

This National Instruments 763061-01 Rev C Type X2 GPIB cable provides a 3.28 ft connection for General Purpose Interface Bus instrumentation. It is built new for engineers and technicians who need a direct link between a controller and GPIB-equipped test equipment.

Suited for standard GPIB instrument chains

The 3.28 ft length fits bench-top setups where instruments sit close to the controller. It is not intended for users who need longer runs across a rack or lab, nor for anyone requiring a different connector type or bus protocol.

Length determines fit

The single specification that decides suitability is the 3.28 ft cable length; if the distance between your GPIB controller and device exceeds this, the cable will not reach.

Highlights

  • 28 ft length keeps bench instruments close
  • New condition guarantees clean contacts and full signal integrity
  • National Instruments branding means factory-tested GPIB compliance
  • Rev C Type X2 design matches specified controller requirements
  • 1 metre metric equivalent simplifies international lab planning

Specifications

Length3.28 ft.

Questions about this item

What port must my instrument or controller have to connect this 3.28 ft GPIB cable?

The cable ends in a standard GPIB connector, so the instrument or controller needs a matching GPIB port.

Will this 3.28 ft cable work with older GPIB equipment I already own?

Yes, the GPIB interface has not changed, so the cable fits legacy analysers, sources and controllers that use the same connector.

How can I verify the cable is functioning correctly after I connect it?

Run a simple device-clear or identification query from the controller; a valid response confirms the link is active.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Network Ethernet Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.