We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black steel wheel hub and bearing assembly with triangular flange, ABS sensor and wiring harness visible

Moog

Moog Wheel Hub & Bearing 4WD Front 2000-2004 Ford F-150 w/ABS 5 Lug

SKU CH-7391-RANFD

Front 4WD wheel hub and bearing assembly with ABS sensor, 33-spline driven flange and five M14 lug bolts for 2000-2004 Ford F-150

  • ColorBlack
  • ABS sensor with 55-tooth tone ring ensures accurate wheel-speed data
  • 33-spline driven hub transfers torque reliably to the front wheels
  • 66-inch wiring harness and round connector simplify ABS installation
  • Tapered steel bearing with 0.94 in inner and 2.12 in outer width handles heavy loads
  • Five M14-2.0 lug bolts and five M14-1.50 flange bolts provide secure mounting

Direct-Fit Front Hub Assembly

This Moog wheel hub and bearing assembly is built for the front axle of 2000 to 2004 Ford F-150 four-wheel-drive models including the 2004 Heritage edition. It arrives new with the ABS tone ring, round-connector sensor and a 33.66-inch wiring harness already installed. The unit bolts to the knuckle with three fasteners and uses a 33-spline driven design for positive torque transfer.

Sealed Tapered Bearing Unit

The tapered roller bearing runs in a sealed steel housing that requires no periodic greasing or adjustment during normal service. Pre-set internal clearances eliminate the risk of over-tightening that can cause excess heat or premature wear. Integrated ABS components maintain factory wheel-speed signalling without additional wiring work.

Bolt-On Knuckle Replacement

Five M14-2.0 lug bolts and five M14-1.50 flange bolts are included so the hub mounts directly to the existing steering knuckle and rotor or drum. The 134.9 mm centre bore and 181.5 mm flange diameter match the original hub pilot and bolt circle exactly. No press equipment or bearing race installation is needed, freeing shop time for other tasks.

Highlights

  • ABS sensor with 55-tooth tone ring ensures accurate wheel-speed data
  • 33-spline driven hub transfers torque reliably to the front wheels
  • 66-inch wiring harness and round connector simplify ABS installation
  • Tapered steel bearing with 0.94 in inner and 2.12 in outer width handles heavy loads
  • Five M14-2.0 lug bolts and five M14-1.50 flange bolts provide secure mounting

Specifications

ColorBlack

Questions about this item

How is the Moog wheel hub installed and which step is commonly done incorrectly?

The hub bolts to the knuckle with three mounting bolts and uses five M14-2.0 lug bolts; the step most often missed is torquing the flange bolts to the M14-1.50 specification in the correct sequence.

What maintenance or replacement will this hub assembly need later?

The sealed tapered bearing is not serviceable; when the 33-spline driven hub wears or the 55-tooth ABS tone ring corrodes, the entire unit must be replaced.

What limit appears first under sustained heavy use?

Heat buildup in the tapered bearing races and the 33.66-inch wiring harness connector typically degrades before the steel flange or 181.5 mm hub diameter shows measurable wear.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.