Monoprice 10ft 2 RCA Plug/2 RCA Plug M/M 22AWG Cable Black

Stereo RCA audio cable for legacy connections

This 10 ft two-channel cable carries analogue audio between components that still use RCA phono sockets. Gold-plated male plugs on both ends resist corrosion and the colour-coded rubber rings give a secure grip during installation. The 22 AWG conductors sit inside RG-59 75 ohm coaxial construction with shielding that blocks EMI and RFI noise. It suits hi-fi separates, older AV receivers, subwoofers or any stereo source and amplifier pair with RCA inputs and outputs.

Replaces worn or unshielded RCA leads

Swap it in when an existing interconnect has cracked insulation, loose plugs or audible hum from poor shielding. The coaxial geometry and braided screen lower the noise floor compared with basic stranded-wire cables, so the upgrade is worthwhile if you hear interference on quiet passages. It also extends the reach between rack-mounted gear where the original 1 m or 3 ft leads fall short. Buyers who need digital audio, multichannel analogue or video over RCA should look elsewhere because this cable carries two analogue channels only.

Check your sockets and routing before ordering

Verify that both source and destination devices present female RCA jacks — typically coloured red and white or red and black — and that the 10 ft length fits the run without excessive slack or tension. The 22 AWG centre conductor and coaxial dielectric add stiffness, so tight bends behind equipment racks may need gentle curves or right-angle adapters. Confirm you require a male-to-male stereo pair; mono, female-ended or digital coaxial variants are different products.