We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White coaxial cable 50 ft long with F-type connectors at both ends

Monoprice Inc.

Monoprice 104061 50ft RG6 18AWG 75Ohm Quad Shield CL2 Coaxial RF Cable White

SKU CH-JP7G-1Z4AX

A 50 ft RG6 coaxial cable with 18 AWG conductors, 75 Ohm impedance, quad shielding and a 2200 MHz rating for reliable RF signal distribution

  • TypeOthers
  • ColorWhite
  • Length49.99 ft.
  • Connector Number2
  • Quad-shield construction blocks interference for clean signal transmission
  • 75 Ohm impedance and 2200 MHz bandwidth support high-frequency applications
  • 18 AWG centre conductor maintains signal strength over 49.99 ft runs
  • CL2 fire-safety rating allows in-wall installation
  • F-type connectors on both ends ensure secure, ready-to-use connection

50 ft RG6 Quad-Shield Coaxial Cable

This 49.99 ft white coaxial cable uses RG6 construction with 18 AWG conductors and quad shielding. It is built for RF signal distribution in residential or light commercial installations. The CL2 rating allows in-wall routing where local codes permit. F-type connectors are fitted on both ends.

75 Ohm 2200 MHz Bandwidth Rating

The cable is specified at 75 Ohm impedance with a 2200 MHz bandwidth ceiling. That single figure determines whether it will carry the frequencies required by your satellite, cable-TV or broadband modem feed. If your system demands a higher verified bandwidth, this cable will not meet the requirement.

Pre-Terminated F-Type Connectors

Both ends arrive with F-type connectors already attached so no compression tool or crimping is needed. Simply thread each connector onto the corresponding port by hand. The main installation risk is over-tightening, which can damage the centre pin or strip the threads on the equipment jack.

Highlights

  • Quad-shield construction blocks interference for clean signal transmission
  • 75 Ohm impedance and 2200 MHz bandwidth support high-frequency applications
  • 18 AWG centre conductor maintains signal strength over 49.99 ft runs
  • CL2 fire-safety rating allows in-wall installation
  • F-type connectors on both ends ensure secure, ready-to-use connection

Specifications

BrandMonoprice
Model104061
TypeOthers
ColorWhite
Length49.99 ft.
Connector Number2

Questions about this item

What does the 2200 MHz rating mean for everyday TV and internet signals?

The cable is tested up to 2200 MHz, so it carries satellite, cable-TV and broadband frequencies without loss.

How does the F-type connector limit the maximum frequency?

Standard F-type connectors on this cable support the full 2200 MHz bandwidth for RG6 signals.

What clearance is needed behind a wall plate for the 18 AWG quad-shield jacket?

The 18 AWG quad-shield construction is thicker than standard RG6, so allow extra depth for the bend radius.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.