MILLENNIUM
MILLENNIUM CC33108ZX 3/8" FIP X 3/8" OD Comp Angle Stop
Connects a 3/8-inch female iron pipe supply to a 3/8-inch OD compression fixture
- TypeTools
- 3/8" FIP inlet connects directly to supply pipe
- 3/8" OD compression outlet fits standard flexible supply lines
- Angle-stop design shuts off flow at the fixture for easy maintenance
- New MILLENNIUM construction delivers reliable shut-off performance
- California Proposition 65 notice: contains chemicals known to cause cancer and reproductive harm
Bath faucet angle stop
The MILLENNIUM CC33108ZX angle stop connects a 3/8 inch female iron pipe inlet to a 3/8 inch outer diameter compression outlet. It is designed for plumbing installations that require a compact shut-off valve at the fixture supply line.
Replaces worn or leaking stops
This component upgrades an existing angle stop that no longer seals properly or has corroded threads. The jump is worth it when the current valve drips under pressure or the handle seizes during routine maintenance.
Handles standard fixture supply duty
The valve comfortably controls water flow to a single faucet or toilet supply line in residential bath plumbing. It runs out when the application demands a straight stop, a different connection size or a pressure rating beyond typical household service.
Highlights
- 3/8" FIP inlet connects directly to supply pipe
- 3/8" OD compression outlet fits standard flexible supply lines
- Angle-stop design shuts off flow at the fixture for easy maintenance
- New MILLENNIUM construction delivers reliable shut-off performance
- California Proposition 65 notice: contains chemicals known to cause cancer and reproductive harm
Specifications
| Brand | MILLENNIUM |
|---|---|
| Type | Tools |
Questions about this item
What size supply line connects to the 3/8 inch OD compression outlet?
Use a 3/8 inch OD supply tube with a matching compression nut and ferrule for a watertight seal on the outlet side.
How do I thread the 3/8 inch FIP inlet onto the wall supply without leaks?
Wrap the male pipe threads with PTFE tape, thread the stop on by hand, then tighten one to two turns with a wrench; do not overtighten.
When should I replace the internal washer or cartridge in this angle stop?
Replace the washer or cartridge if water seeps from the handle packing nut or if the stop fails to shut off flow completely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



