We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four pink 30 cm female-to-female 3-pin ARGB extension cables

MILAKE 4-pack 5V 3-pin ARGB extension cable 30 cm

SKU CH-WYV1-GGP1J

Four 30 cm female-to-female ARGB extension cables connect 5 V 3-pin LED strips or fans to motherboard headers

  • TypeFan-out Cable
  • ColorPink
  • Length30 centimeters
  • Cable Length30 centimeters, feet
  • SpecificationsNO, 5 volts, 30 centimeters, feet, 3 Pin, 4
  • Sports Team1 Piece
  • Extend ARGB lighting with four 30 cm cables
  • Connect 5 V 3-pin fans or strips to motherboard headers
  • Female-to-female plugs install without tools
  • Pure copper cores and PVC insulation ensure reliable signal
  • Four cables and four connectors included in pack

4-pack 5V 3-pin ARGB extension cables

This four-pack of 5V 3-pin ARGB extension cables adds 30 cm of reach to addressable RGB LED strips or fans. Each cable uses a female-to-female 3-pin connector so builders can bridge the gap between motherboard headers and lighting components without soldering. The pink PVC jacket and pure copper cores are rated for 5 V operation. The pack contains twelve pieces total: four extension cables and four loose 3-pin connectors.

Female-to-female 3-pin layout for daisy-chaining

The cables plug directly into a 5 V 3-pin ARGB header on the motherboard and accept the matching plug from a fan or LED strip, extending the chain by 30 cm per segment. No tools are required; alignment arrows on the headers prevent reversed insertion. Because the design is keyed for 5 V 3-pin only, it cannot be used with 12 V 4-pin RGB systems. The loose connectors supplied allow custom termination or repair of existing wiring.

Builders adding 5 V ARGB lighting runs

Suited for enthusiasts extending addressable RGB lighting in a PC case or custom project where the stock leads fall short of the motherboard header. The 30 cm length works for typical mid-tower routing but may be insufficient for full-tower or external strip runs. Users needing 12 V 4-pin RGB compatibility, longer single cables, or pre-sleeved kits should consider other solutions.

Highlights

  • Extend ARGB lighting with four 30 cm cables
  • Connect 5 V 3-pin fans or strips to motherboard headers
  • Female-to-female plugs install without tools
  • Pure copper cores and PVC insulation ensure reliable signal
  • Four cables and four connectors included in pack

Specifications

BrandMILAKE
TypeFan-out Cable
ColorPink
Length30 centimeters
Cable Length30 centimeters, feet
SpecificationsNO, 5 volts, 30 centimeters, feet, 3 Pin, 4
Sports Team1 Piece
Connector ANO, Female-to-Female
Connector BNO Female-to-Female
Connector DetailNO
Terminal GenderFemale to Female
FeaturesNO, 3 Pin, 5 volts, false, Female-to-Female, 4
Disclaimerfalse; not_applicable; NO

Questions about this item

Does the 30 cm cable length limit where I can place ARGB strips inside a full-tower case?

Each cable is 30 cm long, so it works well for nearby headers but may not reach distant fan or strip locations in a large chassis.

Will these cables add noticeable heat or electrical noise when the lighting runs continuously?

The pure copper cores and PVC insulation handle the 5 V signal with minimal resistance, so heat and noise remain negligible during all-day operation.

What motherboard header must I already have for these connectors to work?

You need a standard 5 V 3-pin addressable RGB header; the female-to-female plugs will not fit 12 V 4-pin RGB connectors.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.