We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aqua duplex fibre cable with LC connectors, 10 metre length

Micro Connectors

Micro Connectors 10m OM4 LC/LC Duplex Fibre Optic Cable

SKU CH-49Q0-K58HA

10 m OM4 duplex multimode fibre cable with LC/LC connectors, 50/125 µm core, 4700 MHz·km EMB at 850 nm, supports 10 Gb to 550 m and 40/100 Gb to 150 m, OFNR riser jacket

  • 10 metre reach for rack-to-rack links
  • OM4 multimode supports 10 Gb up to 550 m
  • LC duplex connectors fit high-density patch panels
  • OFNR riser jacket approved for vertical shafts
  • 4700 MHz·km EMB at 850 nm enables 40 Gb and 100 Gb at 150 m

10m OM4 LC/LC Duplex Cable

This 10 metre OM4 multimode fibre cable uses LC/LC duplex connectors and a 50/125 micron core. It is built for high-throughput links in data centres, campus backbones and high-density patch panels. The aqua OFNR riser jacket suits vertical runs between floors. Installers who need single-mode reach or armoured outdoor cable should choose a different product.

Upgrade from OM3 and legacy 50/125

OM4 raises effective modal bandwidth to 4700 MHz/km at 850 nm, supporting 10 Gb up to 550 metres and 40 Gb or 100 Gb up to 150 metres. That headroom matters when you are moving from 10 Gb uplinks to 40 Gb or 100 Gb aggregation without re-pulling cable. Networks staying at 1 Gb or using older LED-only transceivers gain no practical benefit from the higher grade.

Sustained-load behaviour

UPC polish on both ends keeps insertion loss low and return loss above 35 dB, preserving signal integrity during continuous 10 Gb, 40 Gb or 100 Gb streams. The 2.0 mm jacket resists kinking in dense trays, while OFNR rating maintains compliance in riser shafts under constant thermal cycling. Environments needing plenum rating or extended temperature specs require a different jacket class.

Highlights

  • 10 metre reach for rack-to-rack links
  • OM4 multimode supports 10 Gb up to 550 m
  • LC duplex connectors fit high-density patch panels
  • OFNR riser jacket approved for vertical shafts
  • 4700 MHz·km EMB at 850 nm enables 40 Gb and 100 Gb at 150 m

Specifications

No published specifications for this item yet.

Questions about this item

What patch-panel cut-out or adapter plate do I need for the 2.0 mm aqua jacket?

The cable uses standard duplex LC connectors; any panel or plate cut for duplex LC will accept the 2.0 mm OFNR jacket.

How do I seat the LC connectors without damaging the UPC polish?

Align the keyed latch, push straight in until the latch clicks, and avoid twisting — angled insertion scratches the UPC end-face.

When should I re-polish or replace the connectors on this 10 m OM4 run?

Re-polish only if a fibre scope shows pits or scratches on the UPC end-face or if measured loss exceeds the >35 dB return-loss spec.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.