We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three black braided PWM fan splitter cables with 4-pin to 3x connectors, 10.5 inch length

Mickey Technology

Mickey Technology 3-Pack PWM Fan Splitter Cable 10.5 inch internal power cable

SKU CH-W2JV-NVXA0

A three-pack of 10.5 inch PWM fan splitter cables connects three fans to one motherboard header with speed control

  • Connect up to three fans from one header
  • Braided nylon sleeve protects wires from dust and breakage
  • 5 inch length gives flexible fan placement in large cases
  • Daisy-chain multiple cables to extend reach further
  • Supports 4-pin PWM and 3-pin fans with speed control

3-Pack PWM Fan Splitter Cable

This three-piece set lets one motherboard header drive up to three case fans using PWM speed control. It suits builders who need extra fan connections without adding a dedicated controller.

Plug-and-play braided extensions

Each 10.5 inch cable is sleeved in black braided nylon and connects a 4-pin female header to three male plugs — one 4-pin and two 3-pin. The braiding resists dust and snagging, and the connectors seat firmly on standard motherboard and fan pins.

Handles 5 V, 12 V and 24 V fans

The splitter passes PWM signals so all attached fans respond to the same speed curve. It runs out of headroom when total fan current exceeds the motherboard header rating, so high-draw fans may need a powered hub instead.

Highlights

  • Connect up to three fans from one header
  • Braided nylon sleeve protects wires from dust and breakage
  • 5 inch length gives flexible fan placement in large cases
  • Daisy-chain multiple cables to extend reach further
  • Supports 4-pin PWM and 3-pin fans with speed control

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the splitter is sending PWM speed signals to all three fans after installation?

Connect the 4-pin female end to a motherboard PWM header, then observe each fan's RPM in BIOS or monitoring software; all three should respond together to the same PWM duty cycle.

What connectors and accessories are included in the three-pack, and is anything else required to use them?

Each pack contains three Y-splitters, each with one 4-pin female connector splitting to one 4-pin male and two 3-pin male connectors; no extra cables or adapters are needed for standard 3-pin or 4-pin case fans.

The listing mentions 10.5 inch and 27 cm lengths — are these different versions or the same cable?

They are the same cable; 10.5 inches equals 27 cm, so every splitter in the pack provides that length for fan placement flexibility.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.