Maswell Communication Tech.
Maswell Communication Tech. 5G Monopole Antenna 600~6000 MHz TS9
A monopole antenna covering 600 to 6000 MHz with 3 dBi gain, linear polarisation and a TS9 connector for 5G, 4G, WiFi 6, LoRa and Helium mining
- ColorBlack
- Wide 600~6000 MHz range covers 5G, 4G, 3G and WiFi bands
- 3 dBi gain improves signal strength for routers and IoT devices
- TS9 connector fits common 5G and LTE hardware directly
- Linear polarisation and 50 Ω impedance ensure stable reception
- Operates from -40 °C to +85 °C and meets ROHS standards
Broad Frequency Coverage
This antenna spans 600 to 6000 MHz and covers 5G, 4G LTE, 3G, GSM, WiFi, ISM and LORA bands used across North America. It connects via an SMA interface and is suited for routers, WiFi devices, IoT boxes and smart billboards.
Upgrade From Narrowband Antennas
A single wideband element replaces multiple dedicated antennas that each handle only a slice of spectrum. The jump is worthwhile when a device must serve cellular, WiFi 6 and LORA simultaneously without swapping hardware.
Build Integration
Linear polarization and 50 ohm impedance match standard radio front ends, while 3 dBi gain adds reach without needing active amplification. The reinforced plastic and copper construction survives vibration at 10 to 55 Hz with 1.5 mm amplitude and operates from minus 40 to plus 85 degrees Celsius. Buyers who need higher gain or a different connector type will need another solution.
Highlights
- Wide 600~6000 MHz range covers 5G, 4G, 3G and WiFi bands
- 3 dBi gain improves signal strength for routers and IoT devices
- TS9 connector fits common 5G and LTE hardware directly
- Linear polarisation and 50 Ω impedance ensure stable reception
- Operates from -40 °C to +85 °C and meets ROHS standards
Specifications
| Color | Black |
|---|
Questions about this item
What connector does the 600~6000 MHz monopole antenna use to attach to my router?
The antenna terminates in an SMA male connector that screws directly into the SMA female port on your 5G router or WiFi device.
How do I mount the antenna using the U-bolt screw mount, and what step is often missed?
Slide the U-bolt over the mast, place the saddle and washers, then tighten both nuts evenly until the antenna is vertical; the missed step is forgetting to level the radiator before final torque.
Will the copper-wire element or reinforced plastic housing need replacement after outdoor exposure?
The materials are rated for -40 to +85 °C and 10–55 Hz vibration at 1.5 mm amplitude, so no scheduled replacement is required under normal conditions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
