We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four USB A male plugs with red and black bare wires 30cm long

LORDWORLD

LORDWORLD USB A Male 2 Pin Bare Wire 30cm 4 Pack

SKU CH-CX35-G5P1E

Four USB-A male to 2-pin bare-wire cables, 30 cm each, 22 AWG, rated 5 V/3 A with tinned ends for soldering

  • Ready-to-use DIY power lead with USB-A plug and bare-wire ends
  • Supplies up to 3 A at 5 V for low-power USB devices
  • 22 AWG pure-copper conductors with tinned tails for easy soldering
  • Flexible PVC jacket bends freely for tight installations
  • Four cables included, each 30 cm long for compact builds

DIY USB power cable 4-pack

This pack contains four USB-A male to bare-wire pigtails for powering or repairing 5 V devices that draw up to 3 A. Each cable is 30 cm long with 22 AWG conductors, red for positive and black for negative. The tinned wire ends are ready for soldering or screw-terminal connections. Makers and repair technicians can use them to replace damaged leads on low-power gear.

5 V 3 A limit and 30 cm reach

The cables deliver a maximum of 3 A at 5 V, which covers LED desk lamps, USB fans, small light strips and similar loads. They cannot support devices that need higher voltage or current, so high-power chargers or motor-driven equipment are unsuitable. The 30 cm length keeps voltage drop low but restricts placement to positions close to the USB port. Longer runs or higher-power applications require a different solution.

Tinned ends for direct termination

Each pigtail arrives with pre-tinned bare wires, removing the need to strip insulation before soldering or clamping. This speeds up installation on circuit boards, USB socket panels or custom power adapters. The PVC jacket is flexible for routing in tight enclosures. No connectors, heat-shrink or tools are included in the pack.

Highlights

  • Ready-to-use DIY power lead with USB-A plug and bare-wire ends
  • Supplies up to 3 A at 5 V for low-power USB devices
  • 22 AWG pure-copper conductors with tinned tails for easy soldering
  • Flexible PVC jacket bends freely for tight installations
  • Four cables included, each 30 cm long for compact builds

Specifications

BrandLORDWORLD

Questions about this item

Will the USB-A plug on these cables fit the older USB 2.0 ports I still use on my PC?

Yes, the USB-A male connector is backward-compatible with USB 2.0 and 1.1 ports, so it will work with the older sockets you have.

How can I verify the 5 V 3 A output is present after I solder the bare ends?

Use a multimeter on the red and black leads; you should read 5 V with no load and the voltage should stay close to 5 V while the connected device draws up to 3 A.

What comes in the pack and do I need any extra parts to use them?

The pack contains four 30 cm cables with a USB-A plug on one end and tinned 22 AWG bare wires on the other; you only need a soldering iron or screw terminals to attach them to your device.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.