We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten nickel-plated RG59 BNC compression connectors with gold contacts

Logico

Logico RG59 BNC Compression Connectors 10 Pack 75 Ohm

SKU CH-1Y5X-NTGPJ

Ten RG59 BNC compression connectors with nickel-plated bodies and gold-plated contacts for 75 Ohm coaxial cable

  • Secure compression fit for RG59 coax
  • Nickel-plated alloy body resists corrosion
  • Gold-plated center pins ensure clean signal
  • 75 Ohm impedance matches video systems
  • 10 connectors cover multiple camera runs

Pack of ten compression connectors

This pack contains ten Logico RG59 BNC compression connectors designed for terminating RG59 coaxial cable. Each connector uses a one-piece design with a nickel-plated alloy body and gold-plated centre contacts for reliable signal transfer. They are intended for installers and technicians working on CCTV, CATV, satellite or antenna systems. The 75 ohm impedance suits standard video and RF distribution tasks.

Signal integrity and installation

Gold-plated centre contacts maintain low-loss continuity across a 0-3 GHz frequency range. The one-piece compression design creates a mechanically secure joint that resists pull-out and moisture ingress without needing separate ferrules. Nickel plating on the alloy body provides corrosion resistance for indoor or protected outdoor runs. Connectors are compatible with most standard compression crimping tools.

Build integration and scope

Each connector terminates a single RG59 cable end, so the ten-pack supports up to ten cable drops or patch leads. The male BNC interface mates with female BNC ports on cameras, DVRs, splitters or wall plates. No additional adapters or soldering are required once the cable is prepared and compressed. Buyers needing connectors for RG6 or other cable diameters, or those requiring right-angle or female BNC variants, will need different parts.

Highlights

  • Secure compression fit for RG59 coax
  • Nickel-plated alloy body resists corrosion
  • Gold-plated center pins ensure clean signal
  • 75 Ohm impedance matches video systems
  • 10 connectors cover multiple camera runs

Specifications

BrandLOGICO

Questions about this item

How do I install these Logico RG59 BNC compression connectors, and what step often goes wrong?

Strip the RG59 coax, slide the connector over the dielectric until the centre pin seats, then compress fully with a standard compression tool; incomplete compression leaves a loose shield.

What maintenance or replacement will these connectors need later?

Inspect the nickel-plated alloy body and gold-plated centre contacts for corrosion or looseness; reseat or replace any connector that shows oxidised contacts or physical damage.

What limit appears first under sustained use with these 75 Ohm connectors?

The 0-3 GHz frequency range sets the usable bandwidth; signals beyond 3 GHz will degrade before the connector itself wears out.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.