KINGSTON BRASS
KINGSTON BRASS KB101B Columbia Centerset Lavatory Faucet Polished Chrome
Solid brass two-handle centreset faucet with brass pop-up, 1.2 GPM at 60 PSI
- TypeSink Racks & Basket
- Solid brass construction ensures lasting durability
- Polished chrome finish resists tarnishing and corrosion
- Quarter-turn handles provide smooth water control
- 2 GPM flow rate at 60 PSI conserves water
- Brass pop-up drain included for convenient installation
Two-Handle Centerset Lavatory Faucet
This polished chrome faucet mounts on a two-hole sink with a 4-inch centerset layout. Solid brass construction and a premium finish resist tarnishing and corrosion. Quarter-turn handles operate a Duraseal washerless cartridge for smooth on-off control. A brass pop-up drain assembly is included.
Upgrade From Single-Handle Or Worn Fixtures
Replacing a single-lever faucet adds independent hot and cold control with 1/4 turn action. The jump is worth it when the old cartridge drips, the finish has pitted, or the pop-up linkage has failed. The 1.2 GPM flow rate at 60 PSI meets modern efficiency targets while the 2.2 GPM capability supports higher demand.
Check Sink Hole Spacing And Local Codes
Verify the sink or countertop has two holes spaced exactly 4 inches on centre. Confirm 1/2 inch IPS supply connections match existing plumbing. The integrated removable aerator allows cleaning but cannot be swapped for a non-standard thread. California and Vermont regulations restrict this model, so check local compliance before ordering.
Highlights
- Solid brass construction ensures lasting durability
- Polished chrome finish resists tarnishing and corrosion
- Quarter-turn handles provide smooth water control
- 2 GPM flow rate at 60 PSI conserves water
- Brass pop-up drain included for convenient installation
Specifications
| Type | Sink Racks & Basket |
|---|
Questions about this item
What sink hole spacing does the 4" centerset faucet require?
The faucet fits a 4-inch centerset layout, meaning two holes spaced 4 inches apart on the sink or countertop deck.
How do I connect the supply lines to the 1/2" IPS inlets without stripping the threads?
Wrap each 1/2-inch IPS inlet with plumber's tape, hand-tighten the supply nuts, then give a quarter-turn with a wrench; over-tightening cracks the brass.
When should I clean or replace the integrated removable aerator to keep flow near 1.2 GPM?
Unscrew the aerator every few months, soak in vinegar to dissolve mineral build-up, and reinstall; replace only if the screen is torn or flow stays low after cleaning.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



