KINGSTON BRASS
KINGSTON BRASS Concord Two Handle 4" Centerset Lavatory Faucet Oil Rubbed Bronze
A two-handle centreset lavatory faucet with a 5" spout reach, 7-1/2" overall height and a matching brass pop-up drain included
- Solid brass construction ensures lasting durability
- Oil Rubbed Bronze finish resists tarnishing and corrosion
- Two-handle 1/4 turn ceramic disc cartridges give precise control
- 2 GPM flow rate at 60 PSI with integrated removable aerator
- Includes matching brass pop-up drain for complete installation
Concord Two-Handle Centerset Faucet
The Kingston Brass Concord is a two-handle centreset lavatory faucet designed for three-hole sinks with a four-inch spread. Its solid brass construction and oil-rubbed bronze finish resist tarnishing and corrosion. Quarter-turn ceramic disc cartridges provide reliable on-off control. The faucet delivers a maximum flow of 2.2 GPM at 60 PSI.
Three-Hole Centerset Upgrade
This model replaces older two-handle faucets that use the same three-hole, four-inch centreset pattern. The upgrade is worthwhile when the existing fixture leaks, corrodes or lacks a matching pop-up drain. The integrated removable aerator and brass pop-up assembly are included, simplifying the swap without extra parts.
Deck-Mount Installation Requirements
The faucet mounts on the deck with half-inch IPS male threaded shank inlets that connect to standard supply lines. It needs a sink or countertop prepared for three holes on four-inch centres. The spout reaches five inches with a seven-and-a-half-inch overall height and three-and-a-half-inch clearance, leaving room for vessel basins or backsplash clearance.
Highlights
- Solid brass construction ensures lasting durability
- Oil Rubbed Bronze finish resists tarnishing and corrosion
- Two-handle 1/4 turn ceramic disc cartridges give precise control
- 2 GPM flow rate at 60 PSI with integrated removable aerator
- Includes matching brass pop-up drain for complete installation
Specifications
| Brand | Kingston Brass |
|---|
Questions about this item
Will the 4" centerset and 1/2" IPS male shanks fit my existing three-hole sink?
Yes — the faucet is built for a 4" center spread three-hole sink and each shank has a 1/2" IPS male thread for standard supply lines.
What is the trick to installing the ceramic disc cartridges without leaking?
Seat each cartridge fully in the brass body, hand-tighten the retaining nut, then give a final quarter-turn with a wrench; over-tightening cracks the ceramic seal.
How often should I clean the integrated aerator to keep the 2.2 GPM flow?
Unscrew the aerator every few months, rinse debris from the screen, and reinstall; hard-water areas may need monthly cleaning.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



